Electronics Forum | Mon Jun 21 14:55:27 EDT 1999 | JohnW
| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w
Electronics Forum | Thu Jun 17 20:35:51 EDT 1999 | Earl Moon
| | | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | | | for example: | | | | | | Solder Bridge | | | 1.verify amount of flux been aplied. | | | 2.verify turbulance on
Electronics Forum | Thu Jun 17 19:52:57 EDT 1999 | Tony
| | Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | | | for example: | | | | Solder Bridge | | 1.verify amount of flux been aplied. | | 2.verify turbulance on your solder w
Electronics Forum | Thu Jun 17 15:18:54 EDT 1999 | Earl Moon
| Does anyone know where I can find a list of things to do to when troubleshooting issues during the wave solder process? | | for example: | | Solder Bridge | 1.verify amount of flux been aplied. | 2.verify turbulance on your solder wave. | 3.etc.
Electronics Forum | Tue Jul 18 16:25:14 EDT 2017 | Mike Konrad
http://www.aqueoustech.com/trident-pallet
Electronics Forum | Sun Feb 22 08:23:57 EST 2009 | davef
On a wave solder pallet, we'd expect the metal parts that go through the pallet to be warmer than the pallet material, but we don't expect them to be warmer than the solder. We don't expect a well made board to blister at soldering temperature. So,
Electronics Forum | Thu Jan 09 19:55:14 EST 2014 | padawanlinuxero
Hello! I have a problem with one of the products here, we use a pallet to run the board on the solder wave, when the board gets solder and you inspect the board you notice that for some reason the first pcbs that touches the wave are ok, even a litt
Electronics Forum | Mon Jan 13 18:21:54 EST 2014 | vwhipple
A little confusion here. Are you running several boards in one pallet and the last boards are looking poor or is the issue getting worse as the day progresses (like as the pallets get warm)? - If it is the last boards in the pallet, then you may wan
Electronics Forum | Fri Jan 10 11:36:03 EST 2014 | rgduval
One thing you could check/monitor is the temperature in the pot/wave. As boards run across the wave, they will cause fluctuations in the wave temperature. The heaters should hep with minimizing this; but, if you're running a lot of boards in quick
Electronics Forum | Thu Nov 19 10:12:38 EST 1998 | Brian Conner
| For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave solder a
