Electronics Forum | Fri Apr 02 22:01:19 EST 1999 | Dean
| Anyone knows what is the optimum squeegee angle for screen printers. | | 45 Degrees. The forward velocity creates a downward pressure equal to the vector pressure (equalibrium). This is commonly known as paste "rolling action". Too obtuse an an
Electronics Forum | Tue Feb 11 09:47:53 EST 2014 | spoiltforchoice
Perhaps a photo of the faults you are encountering might shed some light on the issue. I would think it would take some extremely poor paste handling or paste for the paste itself to be the root cause of what you seem to be describing. I would be inc
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Tue May 15 13:45:19 EDT 2001 | John
I don't think the syringe pressure has been adjusted, but I'll watch over the next few days to see if it changes (by itself of course). We don't control the humidity in our plant and don't really track it. However, there have been some significant
Electronics Forum | Thu Feb 12 13:01:12 EST 2004 | patthemack
Thanks for your response. This is a DeHaart MPC-29. It has manual vision, no conveyor. When I bought it, only one camera was working. I fixed that, but while I was jacking with that, the electronic pressure regulator (spcjr) burned up without warning
Electronics Forum | Sat Oct 19 08:33:50 EDT 2002 | johnw
The whole thread seem's to have gone off track. Russ we've been doing a fairly big bit of work on the whole BGA voidign thing as we were so unhappy with the answer's that we were getting from around the industry, basically no one really kows all the
Electronics Forum | Fri Feb 03 09:50:37 EST 2012 | mosborne1
Thanks very much everyone. > > I'll try out a > 5mil and see how that goes. If you are using 6mil stencil and you are saying that you need more on the 0603 parts then you might want to look at your squeege pressure. What kind of squeege blades ar
Electronics Forum | Fri Sep 18 00:51:41 EDT 2009 | halleyjoan
I am having problem on the cleaning of our Cyberclean 2000. There is enough chemical, and the wash pressure is also obtained. Yet after performing a cycle, the stencil is not cleaned. What could be a possible cause of not cleaning the stencil?
Electronics Forum | Thu Sep 27 19:52:28 EDT 2001 | davef
All of the discussion of "environmental controls" are a matter of degree, dependent on the requirements of the product that you manufacture. For example: shops assembling under-the-hood products have different requirements than shops making garage d
Electronics Forum | Sat Sep 25 07:07:02 EDT 1999 | Brian
| I need a memory jog. What is the term for the growth of conductive contamination after a board is in storage or field? | There are several different mechanisms which can cause this. In reality, ionic contamination is the root cause for many of the