Electronics Forum | Thu Jul 09 15:17:48 EDT 2015 | goodting
Thanks for the inquiry. We used MCD (Motion Control Dia) tool to verify if that is caused by VRM board. No respond(I means the related axis was off) was detected. we swapped that board to other machine, the VRM card was good.... X axis was stopped, t
Electronics Forum | Fri Sep 11 12:44:16 EDT 2015 | simons
Our Philips Orion shows a L049 motor error immediately after we turn it on. Note that the Y axis servomotor was very hot prior to the last shutdown. Is this a problem with the motor or one of the boards?
Electronics Forum | Wed Jun 01 19:37:15 EDT 2016 | marcelll
You can try to null the axis, it's working sometime Also, lower the acceleration to 2000 instead of 4000 and the max velocity to 350 instead of 508. You can also try to swicht the Y1 driver with Y2 driver Do you have the AMC disks to troubleshoot ?
Electronics Forum | Thu Apr 27 10:25:07 EDT 2017 | dilogic
It's been a while since I posted this message, so I'll give it another try. Any ideas, anybody?
Electronics Forum | Wed Apr 26 05:03:56 EDT 2017 | ariss_t
hi.. try offset the gantry home point.. if cant then.. phewww...
Electronics Forum | Fri Apr 28 18:16:44 EDT 2017 | ttheis
Try cleaning the linear encoder reader. I've had dust build up on two of my machines resulting in failure to calibrate. Blowing out the reader heads with gentle compressed air resolved it.
Electronics Forum | Tue May 02 22:04:54 EDT 2017 | ttheis
Have you reviewed the wiring diagrams and checked voltages at the input card? Maybe you have a damaged IO card or broken cable.
Electronics Forum | Thu May 04 15:32:21 EDT 2017 | dilogic
On the HP Servo panel there are LED's that indicate state of limit switches - so you can see if the problem is in the switch or somewhere else. Did you check it?
Electronics Forum | Mon Jan 28 07:06:26 EST 2019 | dfl
Yes, the left to right movement. The belt looks tight. I will check for loose steps, thanks for the tip. I can't find a mod code for overall speed setting. Do you remember the number?
Electronics Forum | Mon Jan 28 07:37:23 EST 2019 | babe7362000
You could also try swapping the motion cards. X and Y are swappable I believe. And see if the problem goes to the X. I have had to do that in the past for troubleshooting. It has been awhile since I have touched a IVC, but I loved those machines.
