Electronics Forum | Wed Dec 09 07:14:16 EST 2020 | bukas
if you can set bad mark white=good on first machine, black=good on second machine and place same 3 components on them then all is left for 3rd machine not to look for bad mark but just to place remaining components. is board panelized? do some math a
Electronics Forum | Fri Jul 28 09:24:17 EDT 2017 | jpepke468
A lot of our PCB's are being damaged by our water cleaner, it is a Steolting Triton, and I beleive it is due to the drying section in the machine. The air its blowing on the boards is flipping the boards around on the conveyor and smashing small deli
Electronics Forum | Tue Aug 07 05:21:12 EDT 2012 | glichn
Hello Joe, PCB size 6" *6" is larger board. Resistors and LEDs are easy to do assembly. I think you can ask Beijing Glichn, from PCB stencil printer, SMT reflow oven and LED pick and place machine, they can give some suggestion. The investment is de
Electronics Forum | Tue Aug 07 05:29:13 EDT 2012 | glichn
Hello Joe, PCB size 6" *6" is larger board. Resistors and LEDs are easy to do assembly. I think you can ask Beijing Glichn, from PCB stencil printer, SMT reflow oven and LED pick and place machine, they can give some suggestion. The investment is de
Electronics Forum | Thu Nov 12 00:02:45 EST 1998 | Gang Pan
I have just finished this excise which compared Mydata and Quad machine. As the result I purchased Quad QSV-1 model SMT assembler. In my opinion select which one that will depend on your applications. Also depend on what machines you compare with.
Electronics Forum | Fri Sep 21 13:04:58 EDT 2007 | jmelson
Hello, Is anyone using an SMT pick&place machine to insert single contacts into PC boards? I have some boards that have 32 female contacts for 1mm pins, and 16 contacts for 0.5mm pins. I have been using Mill-Max for these contacts, getting the sma
Electronics Forum | Wed Apr 26 22:34:49 EDT 2000 | Eric Chua
1. Verify all the part had load to machine. Get ready for the profile. 2. Run the board with double side tape. Is better to run one board for each machine. 3. Verify all the placement ( missing, misalgnment,etc )and check the value using meter for a
Electronics Forum | Sat Mar 31 11:03:21 EDT 2007 | jmelson
I have a left to right conveyor, so the X offset is larger, but that is not major. You say "Make sure you are teaching with the unit that the machine defaults to or asks for." This is the beam sensor, and I have found no way to change this, either
Electronics Forum | Wed Jan 09 06:37:04 EST 2002 | renocassar
I was contacted in order to set up a factory in order to produce home and car alarms equipment. I wish to use a fully automatic SMT line. That is I want a pcb unloader, glue dispenser, conveyers, Pick and Place machine and unloader. The maximum board
Electronics Forum | Wed Dec 13 02:58:03 EST 2017 | robl
You could use a bowl and track vib feeder to present them, but picking them up and pushing them far enough into the PCB is going to be tricky as they look almost flush mount. Also you need to consider the reliability of the post plated hole diameter
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
