Electronics Forum | Thu Jul 09 12:47:09 EDT 2009 | janz
Hello, We are using F4G software for our Fuji machines. We've 5 machines plug into PC. Recently we tried to connect PC to local network but this only after while close C/C server without possibility to reopen C/C server. Reseting PC gives C/C lice
Electronics Forum | Wed Sep 23 08:19:52 EDT 2009 | rgduval
Check to see if there's a loose cable, or something, that's randomly setting off the light curtain. We occasionally have that problem with some of our flex or 12/16 mags in our TP9, where the tape take up clip is loose (nothing in that feeder) and i
Electronics Forum | Wed Apr 21 14:38:30 EDT 2010 | remullis
Newer Universal Conveyors use 4 wire smema and FUJI should accomodate this protocol in its config screens. Old Universal Conveyors and some machines used SMPI (forget how many wires), You can purchase the 4 wire smema cable from UIC and conversio
Electronics Forum | Tue Jun 01 08:42:08 EDT 2010 | rgduval
I'm randomly having some motor move errors, as well. If you swap your MOT board, and the problem continues, you're down to a couple of problems. Could be that the motor is getting ready to die on you. Could be an encoder problem. Or, could be som
Electronics Forum | Tue Sep 14 17:49:36 EDT 2010 | g2garyg2
The problem with the Sunsda units is that they use a special circuit board, not PLC and Chinese software for programming, so getting into the program to find out what is going on is a problem. Have you replaced the SMEMA cable? I have seen bad ones.
Electronics Forum | Fri Jan 07 02:07:11 EST 2011 | tpappano
Wow, there is a floppy drive hiding inside? I took a peek inside my unit when I first got it and didn't notice one. I will take a closer look! My second unit, that I just got, came with a grab-bag of odds and ends, and I found a ms-dos based utilit
Electronics Forum | Tue Apr 05 14:42:41 EDT 2011 | clampron
Bigvern, We have had the same problem on two different occasions. Both issues were caused by the vacuum sensor. The first time this happened, we had a tech from Dage in to repair. This was fairly costly. When it happened again, we opened the cabinet
Electronics Forum | Thu Jun 30 13:49:15 EDT 2011 | jholif
I am seeing a motor error 4 intermittently during operation. Sometimes it happens as soon as a program starts, sometimes it will perform 1-6 placements and then stop with it. I have swapped the stepper motor driver cards, the EPCU card, the SRX card
Electronics Forum | Thu Apr 19 07:42:53 EDT 2012 | leemeyer
I just purchased a used Universal Instruments Boardflo conveyor model 5363. It looked like it would be perfect to connect 2 of my Quad 4c machines in line. it came with a SMPI to Smema converter box. I connected the box S1PL and S2PL to what I beleiv
Electronics Forum | Wed Aug 22 15:48:03 EDT 2012 | rmitchell
Hi, Our CP8 is down with this message. Parameter: EMG FjMcEmgservoEnable CAM(0),FjlSrvAxis Reset R=304087143 The machine error also has possible broken wire. None of the servo amps show an error they are all (bb) on the led read out We do not hav