Electronics Forum | Fri Apr 20 10:17:47 EDT 2018 | sarcher
We purchased a ERSA Wave Solder 330-F machine recently "As Is", with NO warranty. Trying to get the machine started, we've ran into trouble with the Spray Fluxer ESF. During the initial verification run, the spray fluxer would move 4 times to the ce
Electronics Forum | Wed Aug 29 12:12:14 EDT 2018 | solderingpro
What type of flux are you using today? - Obviously you have already outlined the difference in the parent materials and parent material preparation, so using the same program/profile will not work; the characteristics are different. Try increasing p
Electronics Forum | Thu Dec 26 17:13:43 EST 2019 | rgduval
Doesn't really look like no-clean to me...typically, no-clean encapsulates the solder joint after reflow, trapping any organics. This looks like plain-old water soluble flux, that cooked a bit too much in reflow. As you noted, it cleaned up with
Electronics Forum | Thu Feb 13 09:35:35 EST 2020 | jactomas
Since 6 days we are tryng to solve a issue in our MyData12. For some reason, the TpSys doesn´t start properly and continuesly is rebooting after a message "MMI exited, status = 134, terminating servers - Waiting for Tpsys to finish - MMI returned 13
Electronics Forum | Mon Mar 09 14:16:37 EDT 2020 | oxygensmd
I used to work with S15/F3, was a 10 years ago. 1. Test your machine controllers and station controllers. Load the last program with actuell command. 2. You can check what happening in the SiPlace, switch the monitor to MC, let see all bootup perfec
Electronics Forum | Wed Mar 25 18:34:34 EDT 2020 | spoiltforchoice
> What about designators? Using gerbers to program > a pnp machine was always a last resort to be done > only after much complaining and begging for > proper CAD data. Back in the day I used UniCAM to > program a mydata. After gett
Electronics Forum | Tue May 05 06:50:14 EDT 2020 | greezmky
I am having an issue with our CP-642. It will place fine a great deal of the time however when there is a feeder issue or if the cycle changes, after a part is replenished, it will suddenly miss RS1A diodes on the boards for about five to ten boards
Electronics Forum | Wed May 19 20:24:09 EDT 2021 | kumarb
Thank you Michal. Very much appreciated. We are thinking along the same lines. However, we are being very afraid to even cut the official wire ties that are securing the head 1 and head 2 wiring. We have a new VAC2 solenoid in transit that will arr
Electronics Forum | Sun Jul 18 12:13:06 EDT 2021 | oriolsancheza
Hello, Our machine started to not stopping board into the right position (stop pin was not working we guess). After some inspection we have not seen anything strange. However the DEK software decided to not work anymore. We've been messing arrounf
Electronics Forum | Tue Sep 28 19:22:48 EDT 2021 | kumarb
Hi. Aside from the good advice above, wish to throw in our experience with our 1809EXL. Had < 200 on-hours and the oven would not melt the assorted fresh paste we sourced from different suppliers. The s/w reported that the set temps were being