Electronics Forum | Thu Jun 04 09:53:31 EDT 1998 | Dave F
| I have gold fingers that I want to mask when running over the wave without pallets. They're on the leading edge of the board. I recall seeing rubber boots that slid onto the fingers to mask them. Pop 'em on before the wave; pop' em off after and
Electronics Forum | Wed Jun 03 13:51:57 EDT 1998 | Dave F
Hello: BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints, opens
Electronics Forum | Thu Jun 11 09:34:11 EDT 1998 | Mike Moninger
I'm surprised there hasn't been a response to this. This technique has been around for some time, as it was used early on for memory boards and the like. The pins come on a reel with a carrier strip or strips. Machines are available from the manufact
Electronics Forum | Thu Jun 11 23:35:40 EDT 1998 | Scott McKee
| Does anybody know if a contraption exists that will minimize a PCB's tendency to become slightly bent after reflow? We have a new product that we're planning to assemble in a couple of months. The board is 9.7" by 13.4" and it is imperitive that
Electronics Forum | Fri May 29 14:35:05 EDT 1998 | Steve Gregory
| We are getting solder balls after reflow of surface mount components. We are using a no-clean paste and a new jar seemed to help for a little bit. Any ideas? Thanks in advance Hello Ryan, There's a quite a few things that can cause solder bal
Electronics Forum | Fri May 22 11:12:25 EDT 1998 | Mike Glenn
| | Does anyone know about low pressure/low temperature | | ovens used for baking of moisture senstive | | components? | | Thanks | I need to know from where your need came. I usually just bake in conventional ovens with specified times and tempera
Electronics Forum | Wed May 20 20:16:29 EDT 1998 | D. Lange
| We notice that DI water seems to tarnish or discolor the metal packaging on crystals and DIN connectors. Our marketing types like the shiney metal surfaces. We don't want to hand solder these parts after washing. | Any suggestions? | Dave F Dave,
Electronics Forum | Tue Jun 23 11:08:42 EDT 1998 | Russ Miculich
| Any ideas on what to buy? Only need to build surface mount protos, ability to rework. Is a rework station okay? | Will subcontract production after design is proven. Best bet is to get an Elite or OK Industries manual printer if you are not doing
Electronics Forum | Tue May 12 04:15:48 EDT 1998 | Chris Sargent
Help! We have been doing some trials on Paste Through Hole and have encountered a problem. The screen is designed (as is suggested in technical info re PTH) to give double the paste volume required to fill the void between the pin and via. The pro
Electronics Forum | Fri Apr 24 13:33:25 EDT 1998 | Scott Davies
I inherited a DI system that's um...not in good shape. I would be forever indebted to anyone who could help me with several problems related to this. Flow rate 3.5-5GPM Incoming pressure:50PSI Application: deionized water provided to Electrovert H-4
