Electronics Forum | Fri Apr 08 00:28:34 EDT 2011 | Jacki
We use 7mil stencil to print Epxoy by using printing machine. Not all Tant from the same reel fell down. Some Ok but some misaligh. So, we concluded that Tants with higher terminal fell down while the Tants with lower terminal were fine. I dun say
Electronics Forum | Tue May 03 20:01:24 EDT 2011 | city4497s
It a recent occurance and it happen randomly on other area. I'm using senju M705-GRN360-KV and Indium SMQ 90 Leadfree solder paste, we have been using both paste for 4~5 years. We have asked the oven supplier to perform maintenance and inspection, pr
Electronics Forum | Fri Jul 06 10:35:32 EDT 2012 | ashworth14
All i used to do was blow them with an airline to remove the excess moisture then bake them for 15/20 min at 100' in an oven and that seems to work fine, i did get the info from a 4 stage cleaning guide for the actual cleaning solution we used but it
Electronics Forum | Mon Jun 06 12:51:17 EDT 2016 | wlsmt
My operator applied flux gel ALPHA WS-609 on MG P/N FTH101XAP (CAP ALUM 100UF 50V 20% SMD) before aqueous washing the PCBAs. Solder paste used was ALPHA WS-820. Now the caps have yellow stains. Any solution to this is appreciated. Tks
Electronics Forum | Sat Jun 11 03:26:20 EDT 2016 | nagesh
Hi, I have problem with one of the BGA Top Cap Detached from the Solder Balis attached to the BGA. Advice /Suggest why the Top Cap Has come out. We produced 4150 Pieces & had similar problems with 5 Pieces. Thx in advance for all your suggestions. T
Electronics Forum | Thu Apr 14 15:27:05 EDT 2022 | ppcbs
If it was ROHS I would suspect copper migration. In my experience an acceptable copper finish should last up to at least 6 reflow cycles. If you have bubbles or blow holes in the solder joint, that is a sign of voids in the walls of the copper barre
Electronics Forum | Mon Apr 18 12:39:57 EDT 2022 | winston_one
Thanks for all comments. Process was adjusted normally, problem was in PCBs. Microsection of bare boards confirm that the copper thickness in troughholes was unsuffient, sometimes below 10 microns, on soldered boards where there were a problems durin
Electronics Forum | Wed Nov 02 02:04:43 EDT 2022 | angela t
Bend it for mounting,if it can't be mounted by bending assembly. you can choose other pick and place machine which can handle this flex pcb. How long is this flex board? And do you use jigs when reflow? Could you please send a picture of the jig yo
Electronics Forum | Wed Nov 02 11:20:04 EDT 2022 | proceng1
Is the BLUE area the only place where parts are located? That is a very interesting concept. Why do they NEED to be flattened? Do they ship flattened, or are they installed flat? I assume that the use of flex is because the actual application re
Electronics Forum | Fri Nov 04 12:55:45 EDT 2022 | ibtonystark
We offer to give you the best Lexmark device support that any other company can. Our highly qualified and professional support staff is available around the clock to attend to your needs and provide prompt responses. Feel free to call our assistance