Electronics Forum | Mon Aug 23 20:06:49 EDT 1999 | Peter
I am looking for a source of tooling pins (various diameters) which can be easily attached (ie. taped) to pieces of FR-4 stock to allow for quick and cheap fixtures to run in my smt machines. I've seen these in the past where the pins are attached t
Electronics Forum | Mon Aug 23 20:56:29 EDT 1999 | Dave F
| I am looking for a source of tooling pins (various diameters) which can be easily attached (ie. taped) to pieces of FR-4 stock to allow for quick and cheap fixtures to run in my smt machines. I've seen these in the past where the pins are attached
Electronics Forum | Fri Jul 23 10:47:31 EDT 1999 | Mark D. Milward
There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performing th
Electronics Forum | Wed Feb 23 11:40:38 EST 2000 | TMV
I would definitely check the amount of adhesive/paste that you are putting on the board. It may not be enough for any moving table application. If you think you are OK there, lets go on. As you probably are aware, the HSP tact times can be independan
Electronics Forum | Mon Jul 26 11:01:35 EDT 1999 | Kevin Hussey
| Has anyone ever heard of testing solder paste quality by pasting a board and making a determination of the quality by measuring paste height and width after the board is pasted. Would you consider this a valid test for solder paste testing? | I ha
Electronics Forum | Thu Jul 15 08:34:54 EDT 1999 | Mark Quealy
I use a Transition Automation Semi- Automatic stencil printer with laser cut frameless stencils. My solder paste is an SN63/PB37 RMA 291. I do not operate with in a controlled humidity enviroment. The room temp generally runs around 70 deg's but humi
Electronics Forum | Tue Jul 06 14:33:26 EDT 1999 | Earl Moon
| We are looking for some subcontractors to do surface mount | technology boards for us. Is there anything I should pay specific | attention when I visit the subcontractor's site? | Thank you for any advice | Carol, Someone below mentioned con
Electronics Forum | Thu Jul 01 20:47:48 EDT 1999 | Scott McKee
I called a new customer today and told him that one of his parts on the proto boards (a capacitor with a polarity 'tit') was too long for the pads and the pads were small causing the end opposite of the "tit" to lift up. I suggested that the product
Electronics Forum | Tue Jun 08 10:22:41 EDT 1999 | John Thorup
| Anyone know a independent PCB inspection of BGA (X-Ray). We have several test boards that need BGA inspection. For detailed analysis try X-Tek in Santa Clara, Ca. 408/486-9620 or you can rent the RTX from Glenbrook Technologies for $950 per week 2
Electronics Forum | Mon Jun 07 10:57:31 EDT 1999 | Dave F
| | | | Where I can find some informations about repairing of SMT boards? | | | | | | | | Thanks | | | | | | | | Marcos | | | | | | | A first place to start is IPC's 7711 and 7721 encompasing repair, modification, and rework procedures. | | | |
