Electronics Forum | Mon Dec 28 08:51:45 EST 2009 | jax
What solder are you talking about and what reflow method are you using? High Melt Alloys: SN96 (Sn96/Ag4 or Sn96.5/Ag3.5) - Simliar to SAC305 although normally uses Rosin based flux that can required more extensive cleaning. Pb85 (Pb85/Sb10/Sn5) -
Electronics Forum | Wed Jan 20 17:16:36 EST 2010 | grantf
While on the topic of feeders I would like to ask a question about the Mydata Tube or stick feeders. Due to a shortage of metal forks for the tube feeders we are forced to improvise and use what ever size of fork is available. This is done by notchin
Electronics Forum | Fri Mar 05 08:06:39 EST 2010 | rgduval
Rob, Had that issue early on when we hooked up our Heller. For us, the problem turned out to be the serial communications port on the computer. I can't say we had the black screen, but, we had comm errors. I'd check the following: 1. Cable betwe
Electronics Forum | Thu Mar 11 11:08:22 EST 2010 | geocep
I am using AIM Electropure SN63/Pb37 Solder, & AIM NC266-3 Flux; just like what ACE recommends. I have both Ultra High Pure T-Tanks and a Cryogenic Dewar Tank for Nitrogen, and neither seems to have improved the problem. I place a piece of tempered
Electronics Forum | Sat May 29 02:20:08 EDT 2010 | vinitverma
Mch Adjust > Adjust Target > Laser Unit > Nozzle Position. Here the laser will automatically detect the centre of the nozzle. Remember - It'll give you the option of using a component for the test but DON'T use any component. Let it detect the centre
Electronics Forum | Tue May 18 21:43:02 EDT 2010 | ashley
Hello mickd, 1) The EL data & Vision_type is NOT necessary when using MCS30 for IP1 machine. note : your input of the above might have cause confusion during VP, hence the OS error. 2) I would suggest the following... 2a) lower the Lead_check_are
Electronics Forum | Fri Jun 04 21:27:16 EDT 2010 | deanm
We have a 4 zone Quad ZCR 531B reflow oven with top side heaters only and a mesh belt. Our boards are 2-6 layer, range in size from 2x2 to 7x15, 0402 to D2PAK. What are the limitations/drawbacks of having top side only heat, especially since about ha
Electronics Forum | Thu Jun 24 14:32:59 EDT 2010 | remullis
Not sure what's in your line equipment wise, but you need to know relatively what kind of placements per day you run regardless of the mix. We run around 1.1 million across 5 lines in 3 shift. Calculate what kind of placement per day on a specific
Electronics Forum | Wed Jun 30 00:20:08 EDT 2010 | leadthree
Thanks for your reply. This production lot is already finished. We produced in 2 lots, first was no-clean (and was ok), 2nd lot was cleaned (aqua based), and I need to look into the cleaning further. Since it's all finished I can't get parts from se
Electronics Forum | Thu Jul 01 14:34:39 EDT 2010 | claudea2
I purchased a used QUAD 4C -136 and after a few months got the machine running 8 hr shifts. One issue I have come across is feeder drift. I kept re-aligning the feeder pickup positions but they would always change. Finally I got the time to measure