Electronics Forum | Tue Mar 02 17:26:24 EST 2004 | pjc
I worked on MicroFlex. All axis move via electric motor drive. Carraige reapatability is +/- 0.0005" (12 micron). Cameras position more easily on linear bearings than the swivel type. The alignment accuracy and repeatability easily supports sub-20mil
Electronics Forum | Fri Mar 19 12:09:17 EST 2004 | Primus
I'm just getting more involved with SMT, as I've been a through-hole operator for years. But I don't understand how one could reflow SMT components AFTER the through-hole insertion and solder wave are finished. How does one print paste over a board w
Electronics Forum | Wed Mar 31 20:34:03 EST 2004 | davef
We have not used this specific package. We agree on your toe fillet idea. Toe fillets add no strength to solder connections. This part is a MicroLeadFrame�, which is similar to QFN, BCC, LGA, and whatnot. Consider: * Searching the fine SMTnet Arch
Electronics Forum | Mon Apr 12 07:44:50 EDT 2004 | wgaffubar
Former company we use to replace No Lead BGA's by using dot dispense to apply eutectic solder to pad with same volume the stencil printer. Current company process removes bad BGA, wicks off solder paste then Hot Gas Reflows new No Lead BGA to bare pa
Electronics Forum | Wed Apr 14 05:44:36 EDT 2004 | hun
Hi All, Just have a share with you guy. We are using T4 solder paste and also E-Stencil. We ahd try out Alpha, Kester, AIM and Qualitek. The result show Alpha had a very very heavy stack flux and can't get it clean off even by chemical
Electronics Forum | Thu Apr 29 11:07:03 EDT 2004 | arcandspark
You are right about the very poor support for smaller customers. I had told them we were looking for another paste and now they have sent the reginal manager and the US sales manager has come by to see what they can do for us. All they keep saying is
Electronics Forum | Sun Apr 18 05:02:53 EDT 2004 | Rob
Hi, I am a Quality person (Metalwork fabrication and System assembly)but have not had any experience of SMT before. I am trying to put some SPC in place for reflow and others and have come across something I do not understand. Our current SPC Chart c
Electronics Forum | Wed Apr 28 12:33:05 EDT 2004 | Dave G
Rob, Don't know if you bought an "H" tower with your UP or not. You did you can have a dedicated support plate made from Aluminum that has pockets machined out to match components on the bottom of the board. (Most of the workholder guys can set you
Electronics Forum | Tue May 04 10:59:23 EDT 2004 | Evtimov
Hi, It depends of your boards(are they for SMD or not) and how many boards you assemble. The process at all is like that: 1.Stencil printer - to adjust the paste 2. Pick and place machine(for your quantity) 3.Reflow oven Theese are the machines you
Electronics Forum | Fri Apr 30 10:56:27 EDT 2004 | Bryan She
We tested J6 open on .5mm pitch CSP(In fact,only resistance much lower than normal).J6 is one of the corner ball of the CSP.Defect rate is about 3%. Stencil:4 mil thickness,10 mil square aperture, solder mask openning:10 mil diameter circle. Board fi
