Electronics Forum | Fri Sep 09 10:43:58 EDT 2005 | ???
sounds like the part is being picked up on its side....which means.......it could be.... 1. pickup not taught correctly -- X-Y- or Z 2. head to camera calibration is needed 3. or least likely....feeder problems
Electronics Forum | Tue Sep 27 23:02:55 EDT 2005 | selva Govind
Hi Mark, This problem can be overcome by adjusting the camera brightness - Gain & Offset. I think the offset value is very high. Try reducing it.
Electronics Forum | Fri Sep 23 04:06:43 EDT 2005 | Rob
Make sure you have the 1 mil & 4 mil cameras so you can cover virtually any component.
Electronics Forum | Mon Dec 12 08:05:11 EST 2005 | bobpan
Quad Align.....Cyber-optics....no difference...they both work well. Never tried a micro-bga but i know the upward camera does standard bga parts.
Electronics Forum | Fri Dec 16 13:00:35 EST 2005 | bobpan
At this point.....being my traveling days are done.....i would say call dynatech so they can train you on how to use the upward camera.
Electronics Forum | Tue Nov 15 08:17:05 EST 2005 | cyber_wolf
What are you trying to calibrate? I think you mis-typed...there is no W-wagon. I think you meant X-wagon camera. I have never seen one of these go out of cal. Why do you think it needs calibrated ?
Electronics Forum | Tue Nov 29 06:51:12 EST 2005 | billyd
Thanks dude. There was a broken wire in the big cable. You couldn't tell at a glance, but a very slight tug popped it out. I have it rewired and up and running now. Thanks again.
Electronics Forum | Fri Dec 02 08:10:25 EST 2005 | Amol Kane
Davef and russ, thank you for your input The kester was selected due to a management decision, I shall recommend that other solder be tried out as well. davef, i'll try out the soldering iron......and also look for the green tint (didnt notice that
Electronics Forum | Tue Dec 06 14:56:46 EST 2005 | bigdaddysoy9
Did you update the configuration for the new camera? After changing the configuration I think you have to power cycle the machine for the new settings to take effect.
Electronics Forum | Tue Dec 06 15:19:17 EST 2005 | geb
The install was done by an engineer who does not work for us anymore, so I don't know what was done, the camera operates fine though. Can the size of it be re-configured without re-calibration? Could you tell me the menus to use.
