Electronics Forum | Wed Nov 18 13:13:02 EST 2009 | Everton Sanches
Hello everybody, I would like to know your opinions about Chip Mounters from Samsung. Eg: Models: CP45 , SM411 and SM421. If compared with Juki which its the best machine? Everton - BRAZIL
Electronics Forum | Wed Nov 18 13:31:45 EST 2009 | evertonsanches
Hello everybody, I would like to know your opinions about Chip Mounters from Samsung. Eg: Models: CP45 , SM411 and SM421. If compared with Juki which its the best one machine? Everton - BRAZIL
Electronics Forum | Tue Jan 19 04:53:21 EST 2010 | ptxems
The UK office could offer that software, but its not really worth it as it still requires a lot of further input. Think its just going to be a case of reprogramming all the boards!!! You can transfer from 700 to 2000 series, but not 500 to later mo
Electronics Forum | Mon Feb 08 15:29:38 EST 2010 | ccross
Has anybody had any experience with TRI AOI systems. I just heard of them today (Model TR7550) and was wondering if anybody here has any experience with them. Thanks
Electronics Forum | Mon Mar 01 13:23:29 EST 2010 | joeherz
I'm considering purchase of a couple of smaller McDry cabinets model MCU-301SE. Has anyone purchased these or other Totech products used? Have you been able to get support for consumables? Any info helpful. Thanks.
Electronics Forum | Wed May 26 14:12:57 EDT 2010 | emrtech
the ups in the machine are only for the computer and not the machine itself. we just installed a APC UPS System (model: SUVTF15KBF) that works great, but cost is around 10K. this UPS will protect everything and allows you to run until shutting down w
Electronics Forum | Fri Jun 04 13:23:54 EDT 2010 | mmjm_1099
For the machines that are similar I would start by making sure the model name and machine name are different. The machine type can be the same but you need to add a different sufix at the end or something. See if this helps and should be able to do s
Electronics Forum | Thu Aug 05 12:51:19 EDT 2010 | peteb
Need recommendations on brands and models of reflow ovens for lead free. Small benchtop for prototyping and short runs. Board size about 10" by 10". What works well? What to stay away from? Thanks for any input and advice.
Electronics Forum | Mon Aug 09 07:13:08 EDT 2010 | raghu
We have PVA 354Bench top conformal coating machine. We are going to procure the Humiseal 1B31 material. Is this material is suitable for this model of machine? Is there any special pecautions to be taken while programming? What are the main problemsd
Electronics Forum | Tue Aug 10 01:02:31 EDT 2010 | raghu
We have PVA 354Bench top conformal coating machine. We are going to procure the Humiseal 1B31 material. Is this material is suitable for this model of machine? Is there any special pecautions to be taken while programming? What are the main problems