Electronics Forum: siemens (Page 52 of 81)

Wrong Part

Electronics Forum | Sat Mar 30 10:50:38 EST 2002 | stefwitt

Some earlier machines with mechanical component alignment could be bought with electrical test options ( Mydata, Siemens o.a.). This is, to my knowledge, the only method to identify chip components prior placement. The downside was a high reject rat

Quad Machines? Good Points / Bad Points

Electronics Forum | Tue Apr 23 10:08:27 EDT 2002 | cnoonan

I want feedback from people that currently have these machines or that I have worked with them in recent years. No Quad reps please, although your opinion may be valuable it may be bias to Quad. Here are a few areas of good points and bad point I w

Quad Machines? Good Points / Bad Points

Electronics Forum | Thu May 02 09:08:13 EDT 2002 | darryl

I have a Quad QSP-2 for 5 years and I have had no problems with it. We run it 16 hours per day 6 days a week. Software is good. Service is excellent Quadcare is expensive. The only drawback that I see is tapefeeder repeatability. Seems that the p

Quad Machines? Good Points / Bad Points

Electronics Forum | Thu May 02 12:32:29 EDT 2002 | jmathis

Hello, BUY Juki! Trust me on this one, I have experinced both and I may change careers if I find out I'm going to support another Quad line. There is a reason why that company struggles every year. Quad is not in the same market with the Fuji and

Networking is the Key to Success in the World Today

Electronics Forum | Wed Aug 14 18:32:57 EDT 2002 | cnoonan

To Everyone, Is anyone looking for a process engineer, SMT programmer and/or someone with experience maintaining SMT & PTH equipment? Send me an email and I will forward you my resume... I have worked with Fuji, Universal & Siemens pick and plac

Rating SMT Machines

Electronics Forum | Mon Oct 14 13:39:40 EDT 2002 | peterson

Hi all, I am doing some research on SMT machines. I would like as many people as possible to rate the following machines 1-5. The number 1 would be the best, number 5, the least desirable of the 5. I realize that there are dozens of factors to consi

Used Equipment Support

Electronics Forum | Wed Oct 30 02:53:43 EST 2002 | Frank

The market is ripe with used equipment out there. So a small CM, such as us, are looking to find a good deal out there. I am concerned about being able to get service support from a PnP manufacturer if we buy equipment on the used market. Particul

Used Equipment Support

Electronics Forum | Fri Nov 01 07:58:48 EST 2002 | stefwitt

Thank you, Cal. Indeed I can offer quality support and service on Siemens machines. For the current low prices of used machines, you may want to consider to buy more machines and compensate for down time. As a registered customer you pay $ 40,000 for

TOMBSTONE DEFECTS

Electronics Forum | Thu Mar 20 12:04:42 EST 2003 | Ren� Sandoval

Hello Garcia: For my experience in Tombstone problems I recommend you to check the next points: -Use Solder paste with 2% silver -Use 5 mils Th Stencil -In some machines , for 0402 or smaller componentes , you require an special holder for the feed

mirae pick and place machine

Electronics Forum | Fri Apr 11 16:11:32 EDT 2003 | stefwitt

The question new or used was discussed several times. If you start fresh and have no experience with one or the other machine vendor, I would get a new machine, whose supplier has a service tech in driving distance. If you select the used machine pa


siemens searches for Companies, Equipment, Machines, Suppliers & Information