Electronics Forum: backing (Page 6 of 403)

QP 242 yellow vinyl decal back light for nozzles

Electronics Forum | Wed Aug 02 23:38:47 EDT 2017 | tlake1974

Dose anyone know where to purchase the yellow vinyl decal material by the roll uncut used on the FUJI QP 242 back disk? Any info would be appreciated.

SMT LINE CHOICE

Electronics Forum | Wed Mar 21 17:45:48 EDT 2018 | stephenj37824

We heard back from Ipulse/Yamaha today. I'll have the quote back on the Ipulse M20 tomorrow. I'll keep you posted but the Ipulse seems to be much more cost effective. We are looking at the 12 head version. You guys are great.... Thanks so much!

MY19 Randomly reboots the computer

Electronics Forum | Mon Mar 30 07:33:50 EDT 2020 | bk

Actually the battery back up can cause the exact problem you are describing. Even if you didn't say that I would have said the same thing to check your ups and the batteries. If there is an outlet that by passes the battery back up, use that and see

Re: Banners, error fixed.

Electronics Forum | Tue Jul 14 08:19:29 EDT 1998 | Cunli Jia

I just need to know if anyone else is experiencing this. The banners at the top of the screen are causing interference with my back button. it seems as though each time the banner changes, It's also adding one more step in my history, so when I h

Re: Banners

Electronics Forum | Mon Jul 13 19:10:06 EDT 1998 | Cunli Jia, SMTnet

I just need to know if anyone else is experiencing this. The banners at the top of the screen are causing interference with my back button. it seems as though each time the banner changes, It's also adding one more step in my history, so when I h

Wave Soldering - Icicling/Bridges

Electronics Forum | Tue Jan 28 17:10:21 EST 2003 | sajulius

I've seen this problem on more than one wave,What i've done is to run the conveyor a little faster,use a solder temp of 505 degrees F,and most important is to make sure that the solder is flowing over the back. this will keep the thin buildup of dros

THT connector solder thieves

Electronics Forum | Thu Feb 13 07:13:39 EST 2003 | davef

Tell us more about the location of the bridging [ie, front-to-back, back-to-back, front-to-front, etc]. Thoughts are: * Your annular ring around the hole seems large. You have 0.007", consider 0.003" to be the minimum. Your board fabricator can gi

SPM AV SCREEN PRINTER PROBLEMS

Electronics Forum | Wed Jun 08 09:37:20 EDT 2005 | james

Ok here I go again. I got rid of the last problem but now I am back to a different problem. When the machine sits and I press Reset, the screen reads Starting the Z-axis Homing the Programmable squeeges and just stays there and does nothing. So I

SPM AV Different Problem

Electronics Forum | Wed Jun 08 12:04:34 EDT 2005 | james

Ok here I go again. I got rid of the last problem but now I am back to a different problem. When the machine sits and I press Reset, the screen reads Starting the Z-axis Homing the Programmable squeeges and just stays there and does nothing. So I E-s

What's The Dealy-O With Smocks?

Electronics Forum | Fri Dec 16 11:31:45 EST 2005 | fastek

Does this bring back some awful memories! Back in the mid-80's I worked for a little company called Solectron (yes they were small back then). They wanted everyone to wear smocks and I fought that one come hell and high water. It was all for show as


backing searches for Companies, Equipment, Machines, Suppliers & Information