Electronics Forum | Tue Feb 19 16:26:51 EST 2008 | edatasys
Check out http://www.solderstar.com They have 4 , 6 , 9 or 12 channel products. Software is user friendly and contains predefined specs. for solder paste & reflow ovens. Makes setup quick & easy, also has simulation tools to quickly optimize profile
Electronics Forum | Thu Jan 14 15:36:23 EST 2010 | tds
JBC Tools has a wire solder feed solder iron. You can control how much is dispensed to the tip. I have sold several of these to customers soldering wires in to terminals. The hand piece is bigger than the typical solder iron but it beats the alter
Electronics Forum | Tue Apr 08 22:55:01 EDT 2014 | padawanlinuxero
Hola Beto Here we use this one CAB MAESTRO 3E it's ok does the job well and both blades can take a beating before need to change them. http://www.cab.de/en/electronics/pcb-separators/maestro-3e/ Saludos Beto
Electronics Forum | Thu Apr 17 13:30:30 EDT 2014 | anvil1021
in our opinion unless the Nikon machine has a solution to the Xplane ability to use Tomosynthesis there is a huge difference in the 2 machines. Xplane is a huge quality enabler and we have people beating our door down to get us to look at their perce
Electronics Forum | Wed Aug 12 11:01:37 EDT 2015 | bnorton
Machine->Config and set all their addresses to 0. We have swapped the EPC5, the VGA Video, the Force board, and most recently the Lantern 630VME. Watching the Force board COMM2 with Logicomm, at the end of all the ldx file processing it changes to c
Electronics Forum | Tue May 28 22:19:58 EDT 2019 | Matt
interesting, i will have to check back in with my purchasing department to get the full story here. we are actively getting some samples in from AVX which another user commented on and plan to see how these hold up. unfortunately most faults occurre
Electronics Forum | Wed Mar 20 23:30:43 EDT 2024 | daniel_stanphill
I have heard great things about Viscom. I have seen demos and been thoroughly impressed but do not have any personal experience operating one. I also heard great things about Omron, but they are super expensive I've gathered. A closed loop system by
Electronics Forum | Wed Aug 12 18:06:33 EDT 2015 | bnorton
Here's the end of Logicomm capture on Force COMM2 where it starts the Lantern system not active messages. Couldn't get attach to work. Startup and earlier .ldx file loading omitted ulLoadTasks(): Opening the RFS pseudo device driver ... ulLoadTas
Electronics Forum | Thu Dec 21 22:31:28 EST 2000 | Dave F
Sorry, but I'm a bit fuzzy on the goal here. Let me be basic. The basic reasons for reducing the life of products before they're shipped are: * Design qualification. This highly accelerated test beats the living stuff out of products to identify d
Electronics Forum | Wed Dec 20 17:33:00 EST 2000 | Travis Slaughter
I don�t have the answer for you but it would not be difficult to make a fixture to find out. Combine a counter, pneumatic cylinder, and a solenoid in such a way to do the job for you. Cylinder pushes the card into the connector, when contact is made
