Electronics Forum | Fri Feb 25 09:30:29 EST 2011 | kahrpr
Was the void on the same pad for the 5 failures or were they random
Electronics Forum | Fri Jul 21 12:15:52 EDT 2006 | CKH
Hi Folk, every now and then, i would encounter Functional Failure due to BGA ICs. The Testing Tech always conclude that the contact of the BGA to the PCB Pad is poor. The 2D/3D X-ray machine can't detect any of the poor contact on the BGA..... We
Electronics Forum | Tue May 20 06:00:33 EDT 2008 | roc2x
Im qualifying a new PCB. I run 2 diff supplier. Supplier A has Zero failure. Supplier B has 4 failure all having Lifted PAD on Bga same location and same location pads that lifted. How can I prove that the PCB have problem? Input : Both run in same o
Electronics Forum | Wed Jan 03 09:59:52 EST 2007 | Jim
Hi, I was looking for information on failure rates for BGA components. I am analyzing our BGA rework rates and find it difficult to define a root cause when a remove and replace of the BGA component corrects the test errors. Inspection prior to re
Electronics Forum | Wed Apr 22 07:54:18 EDT 2009 | clampron
Cood Morning, We have a similar situation. We have had a large volume (5K) of RoHS BGA's reballed with 63/37. We have had only a few failures most of which do not appear to be related to that particular BGA. Potential BGA failures are running under
Electronics Forum | Mon Jun 18 18:17:10 EDT 2001 | davef
What to you consider to be the minimum resolution [micron] for: General, BGA, die attach uBGA, flipchip, wire bonds Wire cracks, delamination Microcircuit failure What is the relationship between resolution [micron] and the kV of the tube?
Electronics Forum | Wed Sep 02 06:50:55 EDT 1998 | Masdi Muhammad
Hi, We are having problem with yield loss due to electrical fail. Further investigation shows that the failure is due to solder bridging under BGA. Has been there any study or experience on how this could occur and what we can do to prevent it. Than
Electronics Forum | Sat Jul 27 14:30:56 EDT 2002 | Juan C. Ruiz
Do you have any picture or reference how can we determine black pad or plating contamination. I have heard about a lot of problems regarding BGA's and normally these components are only replaced or heat it and that's it ,after that the boards are wor
Electronics Forum | Tue Jul 25 08:34:30 EDT 2006 | GS
Does your board passes also through the wave solder step ? If, yes, it could be a matter of secondary reflow on BGA ball solder joints. Best Regards....GS
Electronics Forum | Mon Jul 23 14:39:11 EDT 2012 | hegemon
I would think that wave solder beneath a BGA component might be a little bit stressful. The board will be expanding much faster than the BGA on the topside. This will cause some stress to the solder joints that might show up as the failure you are