Electronics Forum | Tue Sep 14 02:12:22 EDT 2010 | genesan
Hi Sir, Thanks for reply and base on our system the same part are using for 2 model only and the problem occur on both assembly.By the way as feedback it happen on random pin of this BGA only.
Electronics Forum | Sun Sep 07 09:57:23 EDT 2008 | davef
We have BGA connectors on rigid laminate. Points are: * We love BGA connectors for mating mother/daughter boards because they eliminate the wave solder step required for PTH connectors. * BGA connectors are very tricky to assemble, much trickier than
Electronics Forum | Mon Jun 08 14:52:46 EDT 1998 | Mike
| How do I mechanically/visually inspect BGA devices when they are soldered to a PCB for possible solder, or other, defects as a first step before part removal and further analysis? I have had board failures due to poor soldering--I think? I can pr
Electronics Forum | Mon Jun 08 16:20:43 EDT 1998 | Earl Moon
| | How do I mechanically/visually inspect BGA devices when they are soldered to a PCB for possible solder, or other, defects as a first step before part removal and further analysis? I have had board failures due to poor soldering--I think? I can
Electronics Forum | Sat Jul 04 01:25:31 EDT 2009 | magnifico
Hi All, I am new in this forum and I'd like to ask for anyone's help in the programming of Fuji QP 242e. We had this machine from a company branch that closed last month and I have limited knowledge about this model. Just the basic steps would do.
Electronics Forum | Fri Mar 27 05:11:24 EDT 2015 | robertwillis
If you want a step by step guide on BGA look at my NPL/IPC "Defect of the Month" video clips https://www.youtube.com/watch?v=MC4K0eSXH18 For other process issues there are also videos which may assist on other process issues like voids, solder ball
Electronics Forum | Thu Nov 14 11:08:29 EST 2002 | bcceng
Kevin, I have done the following process to a similar problem: 1. Plug holes (even to both sides of the board) 2. Clean any flux left on the surface, especially on bottom side. 3. Apply Kapton tape to the bottom side, you mite want to apply 3 layers
Electronics Forum | Thu Feb 28 16:40:04 EST 2002 | liviuj
>Dear SMTneter, >>I am loonkig for some information about how to rework a >>BGA. >>Some technical info explaing how to put solder past >>manualy, soldering manualy, tips and so on. >>Where can I find something about? >>Thanks in advance >>Marcos Hi
Electronics Forum | Tue Jan 21 10:55:26 EST 2003 | MA/NY DDave
Hi From what you write no one here should have an answer since too little data is supplied. You might need to go to an FEA modelling shop to model the stresses and observe fatique life, or find a group to discuss your process and your application p
Electronics Forum | Fri Sep 17 08:03:04 EDT 2004 | soease
Hi Simon, thanks for answering so fast. Well, our company is building several different products to monitor turbine activities (power generation and propulsion). So our boards are equipped with mixed technologies including minimelfs, 0402 chip resis