Electronics Forum | Thu Oct 21 16:08:16 EDT 2004 | Dzyna Kid
Does anyone know of any resources I could investigate to make a small circuit that would consist of a transmitter, receiver, and a motor. I want to be able to press a button on a remote control and that would make the motor turn on, then I want to b
Electronics Forum | Fri Oct 06 09:03:07 EDT 2006 | RLM
Is anyone familiar with the automatic needle calibrator #820-10 for a Camalot 1818. It looks like a simple device but when I follow the instructions to create the calibration program all I get is the needle crashing down onto the calibration button.
Electronics Forum | Mon Jul 11 21:46:19 EDT 2011 | garym4569
Anyone know how to enable pick tracking for the Juki 730 and 760. Our Juki 750's and 2060 allow me to press the camera button during a production stop to manually check pick position with the camera if the machine stops for no component, laser recon
Electronics Forum | Fri Jul 29 18:00:31 EDT 2011 | daveatdt
There should be a "Tracking" button at the bottom of the screen that you can just tab over to, then press the green start button. I have not worked with the 730, but it is that way on our 740, 750, and 760 machines. Alternatively, you can move the cu
Electronics Forum | Thu Sep 29 10:34:46 EDT 2011 | leemeyer
I recently bought a used Universal conveyor #5362I. All I need it to do is pass through boards from 1 machine to the next without operator intervention. The only way I can get it to accept a board from the upstream machine is by pushing the yellow bu
Electronics Forum | Wed Apr 25 14:10:00 EDT 2018 | irc
hello, I'm learning to use the oven 1809 exl and when I try to put it on the Estop button is on all the time and allows use of the oven I read in the manual but I can not find an answer to deactivate it, could you tell me how I can disable this butto
Electronics Forum | Thu Apr 26 02:32:44 EDT 2018 | bukas
1. check both e-stop buttons are released 2. reset e-stop with blue reset button 3. open Alarms menu(there is icon) 4. acknowledge alarms(next to alarms menu icon) 5. clear alarms(next to acknowledge alarms icon) 6. go back to operating interface(thi
Electronics Forum | Fri Feb 01 07:21:32 EST 2019 | dfl
One of my 8mm feeders is blinking the red led after the pick-up. With both buttons the motor works as expected (forward/backward), but after the nozzle pick-up the motor moves forward and then the red led blinks. pressing the buttons the green led l
Electronics Forum | Mon Apr 22 14:06:25 EDT 2019 | kgarlapa
Yes it is a Kanetic edge belt conveyor that was manufactured by Kanetic in Lake Barrington Illinois. I tried holding the reset/start button and also tried to cycle the power after after holding the reset button, No Luck.Do you know if Kanetic is sti
Electronics Forum | Mon Aug 17 15:19:16 EDT 2020 | jmelson
I have a (new to me) Quad QSA-30A that I just got about a week ago. At first, I could get it to go ready most of the time, now it will never go ready. I have traced the ready button into the DPRAM board and the logic is OK all the way into one of t