Electronics Forum | Thu Aug 10 12:30:35 EDT 2023 | dimamalin
We are using a SAMTEC BGA connector.
Electronics Forum | Thu Sep 25 22:36:41 EDT 2003 | fastek
It wasn't that long ago that your beloved UIC was attempting to charge $20K to license a GSM. Are you saying they don't have a license fee structure any more? I bet they still do. I feel the fees charged by the SMT OEM's are justified as many are as
Electronics Forum | Fri Sep 09 16:53:03 EDT 2005 | stepheniii
If there is a small place near you, they might even put one IC on a board at no cost. I've worked for a couple of contract manufacturers and both have done a couple jobs so small I can't see charging the person for. It would probably cost more in ad
Electronics Forum | Wed Jan 11 10:50:09 EST 2006 | beta
All, Current supplier of Solder bar charges for Pot Analysis to be carried out. �60 a go. They say that they get charged so they pass it on, With the imminent change over to leadfree this rule still applies. Anyone know of a Lab etc. in Ireland th
Electronics Forum | Wed Feb 14 15:01:59 EST 2007 | davef
Latex is not a conductor. It's an insulator. So, it will not conduct a charge to the metal wire rack. You can test this hypothesis by charging a latex tube in the shop and measuring its conductivity to ground. We believe that you should not have
Electronics Forum | Tue Mar 16 21:42:29 EDT 2010 | aqueous
Aqueous Technologies would be glad to send you a manual. Product registration is now free. Upon registration, Aqueous Technologies will send you manuals (electronic copies) at no charge. Service is available on a charge basis. Mike Konrad Aqueou
Electronics Forum | Wed Jan 30 12:04:28 EST 2013 | caerleon
We have a device that uses the same technology of Li-Ion battery. We had a problem with charging and over charge part of the circuit. The issue was that the battery and the charger had the same inbuilt safety circuit to protect it from overcharge and
Electronics Forum | Thu Jul 07 01:26:34 EDT 2016 | lukvel
I have not tested whether there is electrostatic discharge on the PCB or not because the electrostatic meter is still on its way. But the IPC-A-610 section 3.1.2 specifies that yes even compressed air nozzles that move air over insulating surfaces g
Electronics Forum | Wed Apr 11 14:41:29 EDT 2018 | charliedci
We have used DEK for over 12 years, can remember only a handful of times they mis cut a stencil and have always stood up and replaced at no charge with no argument. Have missed their "same day" shipping a bit of late, but overall we're very satisfied
Electronics Forum | Mon Aug 07 20:43:42 EDT 2023 | smith88
I am looking for some tips of the trade with solder charges. I am using recommended reflow profile in the oven and I am seeing insufficient fill per IPC, and sometimes insufficient end joint. I have tried dipping them in flux also. What are you a