Electronics Forum | Thu Jan 03 15:20:02 EST 2002 | Luis F. Otero
What method of depanelization is used to depanelize circuit boards made of flexable ribbon cable material.Any input welcomed. Luis F. Otero (915)-780-5504
Electronics Forum | Tue Dec 15 15:26:23 EST 1998 | Chrys
| Trying to locate a company that I believe was called Addative Technologies, previously located in Tyngsboro, Ma. | | Process is the addition of circuit traces utilizing a conductive ink that is fired and can then be run through the normal processi
Electronics Forum | Thu Apr 09 22:50:50 EDT 1998 | Larry
Configuration of our HP 3065 in-circuit tester: HP3065 HL testhead with CL+ controller with 2 hard drives and tape drive 11 Hybrid cards 4 Analog cards 1 GP relay card 2 DUT power supplies (6038A) 1 HP color terminal (2397A) 2 HP terminals (700/92 an
Electronics Forum | Fri Sep 13 14:22:37 EDT 2002 | davef
If that's the case, it's most likely the radio is bad. Again, I'm not clear, but it sounds like using the MD is the trigger to shut the player down: * Stop using the MD. * Fix the MD or some of the associated power supply regulation circuitry. For
Electronics Forum | Fri Sep 13 14:33:32 EDT 2002 | Simon
Thanks to all of you. This is very kind. I'll have a good poke around the circuit board for loose / hot components - good tips. I think it might be a throw away job, but I thought I'd give it a last try. You guys have actually given me much more
Electronics Forum | Mon May 27 18:59:24 EDT 2002 | Armynski
Carol, That time is also acceptable (2 Hrs @ 125 deg C) u can use this too... 6 Hrs @ 75 deg. C regards, Dreamy
Electronics Forum | Tue Jun 16 11:04:11 EDT 2015 | cyber_wolf
Who are the experts in the U.S. regarding polyimide bare board manufacturing ? We are struggling with warpage issues....
Electronics Forum | Mon Sep 16 12:56:56 EDT 2002 | dragonslayr
simon- davef is on the right track. 1st year electronics courses teaches us that you should always check the power supply first. In this case, the power supply in question is not your power source but the regulated power within the unit. I suspect o
Electronics Forum | Thu Jan 03 22:39:37 EST 2002 | davef
For us, it depends on product volume: * Low volume: Tailor's scissors sharpened for the job. * Mid volume: Custom die used in a press. * High volume: We don't do this, but we'd have buy a singulation machine, er something like that. [Search the SMTne
Electronics Forum | Mon May 27 18:25:03 EDT 2002 | Carol Stirling
Thanks for the information Reworkman, We are leaning to the theory of better safe than sorry. I think I'd supply the bags and dessicant just to eliminate manufacturing issues. What temps & times do you ask your boardhouse to bake to? Ours said some
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400