Electronics Forum | Sat May 22 22:31:21 EDT 2004 | snehal acharya
hi to all, pls give me the detail chart for mil to mm/cm conversion if any since in SMD line all things we were talk is only in to mil so some time i get confused , for this pls clear my doubt you all genius seating there & pls don't laugh the questi
Electronics Forum | Tue Jan 27 02:00:40 EST 2009 | sachu_70
Your image does not clearly explain the problem. However, I can see a good heel fillet formation at the joint. In general, TSOP leads are delicate and should handled with immense caution and good ESD protection. First let us be clear that any "rework
Electronics Forum | Mon Dec 27 07:12:54 EST 2010 | clampron
Good Morning Methos 1979, I have worked with the Mirtec MV2 and 3 for several years. I did perform some evaluation of the red/blue filters. We found it to be usefull for some specialty solder inspections but we found it most usefull for solder inspe
Electronics Forum | Wed Aug 12 14:35:33 EDT 2015 | ehess
having a problem with several heads miss picking 8mm feeder parts. Had to bypass 2 of the heads because it was becoming such a hardship. Heads 3, 4 (bypassed), and 8 (bypassed). On 3 and 8, it will miss so many it errors, and when I clear the erro
Electronics Forum | Tue Dec 31 02:04:19 EST 2019 | sssamw
From the picture, I cannot see clearly solder ball violate electrical clearance or cause a short, maybe it is. What I can see is the solder paste has some misalignment although it doesn't printed in solder mask area, but actual position will reduce
Electronics Forum | Thu Mar 04 15:01:32 EST 2021 | proceng1
We used to have 5 of these in service and they worked great. Only 1 had the stencil wiper, and we did not utilize it. We've since installed all inline printers, but we do keep 1 MV100 on the floor as a back up. The firmware can get squirrely and the
Electronics Forum | Mon Dec 11 20:45:59 EST 2000 | Dave F
Sure you can do it!!! Just so that I'm clear on your inquiry, the pattern you're talking about is what? * Foot print of the copper pads * Glue pattern for printing your adhesive
Electronics Forum | Wed Nov 01 18:20:29 EST 2000 | massimo
Thank you Wolfgang, I've found something usefull in the thread, even if unfortunately nobody talks about the design of the nozzle. About the warpage, I clearly see the warpage of the corners of the BGA. To avoid it I'll keep the temperture of the nit
Electronics Forum | Sat Oct 21 23:49:22 EDT 2000 | Garth Fitzner
I have been wave soldering LCD's for about five years now and have done many thousands. As someone else mentioned they go dark when heated but then clear as the temp comes back down. The amount of failures attributable to the wave process has been l
Electronics Forum | Tue Aug 29 10:55:12 EDT 2000 | Steve Thomas
Earl, I emailed you prior to seeing your very informative post. Let me know if you got it so I know if that's a valid email or not. Very interesting. We clearly have some thinking to do.....
