Electronics Forum | Sun Oct 11 21:19:51 EDT 2009 | fulldrawmike
we have both flexjet and flexhead, we also have the new inline 7 head on some genesis dual beams we just put into operation. If you have a choice in flexjet heads take the inline 7. The flexjet 09 head is very labor intensive, stay away from them, e
Electronics Forum | Fri Aug 28 12:05:12 EDT 2015 | davef
“The global automotive industry demands world class levels of product quality, productivity and competitiveness as well as continual improvement. To achieve this goal many vehicle manufacturers insist that suppliers are certified to the quality manag
Electronics Forum | Tue Jul 09 15:20:19 EDT 2002 | pjc
When you look at the capabilities of Combo machines they tend to sacrifice performance when compared to separate X-ray and AOI machines, meaning they don't do either the X-ray or AOI operations as well as a machine that was designed to do only one. A
Electronics Forum | Tue Apr 27 05:26:14 EDT 1999 | Charles Stringer
| | Hey MoonMan, | | | | Did I catch in one of your fabulous threads that you're using Tetra stencils? I'm anxious to find out how you're liking them. | | | | We we're all set up to go to Tetras, then mgt decided to close down our factory - Dooop!
Electronics Forum | Tue Apr 27 09:26:43 EDT 1999 | Chrys Shea
| | | Hey MoonMan, | | | | | | Did I catch in one of your fabulous threads that you're using Tetra stencils? I'm anxious to find out how you're liking them. | | | | | | We we're all set up to go to Tetras, then mgt decided to close down our factor
Electronics Forum | Tue Jul 29 14:20:03 EDT 2008 | realchunks
Slight variations should have little impact on your product under normal conditions. All depends on your board.
Electronics Forum | Wed Mar 11 10:47:08 EST 1998 | Jim Gurley
Need to sell machine with about 40 feeders. Excellent conditions. Located in Melbourne Fl and asking $25K
Electronics Forum | Tue Mar 18 11:53:58 EDT 2014 | sara_pcb
Our contract manufacturing agency have procured pcbs from approved vendor. After assembly we found solder mask separated from the PCB on the epoxy area as patches. The top side is intact. also over the pcb tracks, the mask got damaged. In what c
Electronics Forum | Mon Dec 17 12:06:58 EST 2007 | pjc
5 Steps to Eliminate Bridges: 1. Establish (wave) Parallelism First and foremost, you must establish board-to-wave parallelism. This is the prerequisite to any wave solder process control. For an understanding of the power of this approach go to ht
Electronics Forum | Mon Aug 24 07:32:34 EDT 2009 | hurr
Hi Joane, this flux is primarily designed for wave soldering. I think that manual soldering it´s possible. Certainly it´s very hard to dispensing correct amount of the flux. Succinic acid is one from all ingredients of this flux. If you have this