Electronics Forum | Fri Feb 28 13:41:24 EST 2003 | ksfacinelli
Thanks for the info Russ.....
Electronics Forum | Thu Sep 01 00:52:24 EDT 2005 | adlsmt
Depending on the connector you should be able to use a standard cheap arbor press with some cheap home-made tooling. Standard arbor presses typically have a rotating disc with cut-outs, remove this and put a decent quality stainless steel block in it
Electronics Forum | Wed Sep 08 05:51:24 EDT 2010 | 15009
SIPAD solid solder deposit solves this challenge.
Electronics Forum | Thu Sep 23 15:52:00 EDT 2010 | aj
thanks everyone... Not running huge volumes at the moment but all comments are greatly appreciated. aj...
Electronics Forum | Fri Nov 08 05:40:54 EST 2019 | leeg
We place these on a few boards and have no issues with reflow or warpage. How thick is your PCB?
Electronics Forum | Fri Jul 23 06:44:33 EDT 1999 | George Verboven
| First of all, I'm a young Spanish so sorry for my English | | I'm looking for a smd single pin connector. I need it to solder it in a alumina's substrate. | | Please. can anybody help me ? | Go to the following adress: http://www.keyelco.com/ke
Electronics Forum | Fri Sep 17 16:44:56 EDT 2010 | rdubya
If your pads are long enough you shouldn't have a problem, the pins on the connector are curved up(away from pcb)and will plow solder paste to the end of the pad then it will wick back up the pin during reflow. if you have a second stencil for the bo
Electronics Forum | Thu Nov 07 10:07:02 EST 2019 | charliedci
Requesting help from anyone with experience in reflowing Te Connect, PN 1565917-4, 200 pin connecter. Pic attached. Cannot get all 200 pins to wet, main suspect is slight PCB warping during reflow. Have adjusted reflow profile. A 2.75 inch long SMT c
Electronics Forum | Wed Feb 12 13:37:22 EST 2003 | dwanzek
I need some input on what good solder thieves dimensions should be. I am limited to solving my bridging problem with solder thieves; all process/wave variables have been adjusted to try to solve this problem. There are several of these connectors on
Electronics Forum | Thu Jul 28 05:41:22 EDT 2005 | K
Hi guys, Have any of you encountered harwin connector M80-647 in the past? Have you noticed any problems with the reliability of the component, solderability and 'reworkability' (thats a new word for sure)? Heres a PDF of the component; http://www.
