Electronics Forum | Mon Feb 25 12:21:16 EST 2008 | stevek
Rather than having the artwork cover the via as with tenting dry film, and letting the mask do what it will, the preferred way is to do a second op silk screen with something like SR1000 just in the vias themselves to plug them. This doesn't always
Electronics Forum | Fri Dec 17 14:30:42 EST 2004 | Dreamsniper
I goy this issue: Voids in almost every ball of my BGA's prcessed since we changed our BGA via tenting to double tenting. The tenting is done with a dry film application to fill the via from the solder side then apply LPI Mask on the surface of the
Electronics Forum | Fri Dec 17 14:31:52 EST 2004 | Dreamsniper
I got this issue: Voids in almost every ball of my BGA's processed since we changed our BGA via tenting to double tenting. The tenting is done with a dry film application to fill the via from the solder side then apply LPI Mask on the surface of the
Electronics Forum | Mon Mar 04 11:08:56 EST 2002 | Matt Kehoe
We have a customer that desires to have their via holes plugged with solder after assembly. Is it possible to add the via holes to the stencil and print paste into them and expect them to plug? If so, how much paste? One to one on the stencil opening
Electronics Forum | Tue Jul 22 20:38:28 EDT 2003 | Paul T.
Have the PCB fabricator use a conductive paste to fill the vias and then finish by plateing over the via. Make sure it's coplanar to the side they're on, usually secondary side for discretes. PT
Electronics Forum | Fri May 10 09:07:42 EDT 2002 | xrayhipp
Does anyone know a surefire way to print micro-vias which are centered on BGA pads and also reduces solder ballooning? Would you design a process around two stencils? -- one for the vias themselves and one for the pads. Could you fill all of the vi
Electronics Forum | Mon Dec 02 08:43:20 EST 2019 | scotceltic
What are people using out there for minimum spacing between vias ? We recently came across a PCB manufacturer that wants us to increase our spacing due to their process. Below is our current spec. that we follow. Spacing between via pad to via pad o
Electronics Forum | Fri Nov 23 16:32:05 EST 2007 | davef
There a several things you can do to prevent the solder wicking down the hole with the current design, and that's where you should focus. Cost goes up as you go down the list, but in neither case do you need to respin the board, have solder starvatio
Electronics Forum | Sun Jan 09 19:37:15 EST 2005 | Bob R.
I'm just thinking out loud here with no experience to back it up, but I could see where you're trapping air or solvent filled voids inside the via by tenting from both sides. When you go through a heat cycle like reflow or wave solder you could be e
Electronics Forum | Tue Dec 17 16:27:02 EST 2002 | davef
I�m not clear on the problem. What I get: * Your fabricator did not deliver the product that you asked for in your purchase order. * Pad. Land. A portion of a conductive pattern used as a termination area. Metal surrounding a hole on a printed ci
