Electronics Forum | Thu Jul 31 13:58:48 EDT 2014 | jimmyboz
I meant to end the last post with "month will get worse".
Electronics Forum | Fri Aug 01 08:15:49 EDT 2014 | kurtiss
Thank you, Kurtis
Electronics Forum | Fri Aug 01 12:04:54 EDT 2014 | jimmyboz
That's great.
Electronics Forum | Tue Dec 14 14:49:57 EST 1999 | Larry Johnson
Okay, I have recently found tiny little ball bearings in side our CP4-2. Some have even been reported by operators to be found on top of the PCB while it is running. We have found about ten total so far, any ideas of where these would be comming fr
Electronics Forum | Tue Nov 23 16:07:47 EST 1999 | Larry Johnson
I am currently having trouble writting a PD for the part that is layed out in the link below. I am placing this part with a CP4-2 with SMD3 vision. I think my main problem is with the Vision #, but if you would please take a look at the link below,
Electronics Forum | Tue Sep 14 13:51:20 EDT 1999 | Earl Moon
| Is it possible to place 0402 components with a Fuji CP2? How about a CP4? What are the suggestions for 0402 machine placement? | | Any help would be appreciated. | Never had a CP2. Had limited success on CP4's. Do better with 6's and some newer
Electronics Forum | Fri Mar 13 00:11:16 EST 1998 | Rob Cass
| | Has anyone had any success in repairing Fuji CP nozzles in house? Removing bent press fitted nozzle and replacing. Any input would be appreciated, please no solicitation from repair shops | Rob, | What model of CP? Mr. Kooki CP4 and 6 Mr. Kooki
Electronics Forum | Fri Apr 14 13:36:44 EDT 2006 | cyber_wolf
Dax, More than likely your moveable rail is slipping on the X-Y table. Make sure there is no oil where the breaks grab the table. Sometime the breaks wear out and need replaced. The contact surface on the break lever is only a couple of thou.. We hav
Electronics Forum | Mon Jul 10 16:37:10 EDT 2006 | mac
Hi All, Lately we have been getting a humming noise which seems to be coming from one of the D-axis motors on the CP4. If it happens the Op. hits the e-stop and resets the machine which clears the noise and machine runs fine. Obviously there is a
Electronics Forum | Fri Feb 01 05:42:21 EST 2008 | aj
Hi all, Is anyone out there placing 0402 with a CP4? Not sure how reliable it would be and also how do work around the nozzle setup ? we currently have 2.5mm ,1.3mm & 1.0mm so do you remove say 6 x 2.5mm and put in 0.7mm. Any replies appreciated.
