Electronics Forum | Thu Jan 19 06:39:56 EST 2006 | dougs
It's been a few years since i worked on a CP machine but your st17 & 19 errors are probably down to grease in the clutches at the top of the shafts, if too much grease is put onto the turret gear during maintenance it tends to spray into these clutch
Electronics Forum | Mon Jul 13 09:34:32 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Fri Jul 10 18:47:27 EDT 2015 | alphatronique
make sure noting stock in the X ,and motor brake work usually machine supply 24V to motor brake wire for release brake then move until hit the end stopper for init motor if brake keep on that will the error message i got it often on the Z cause
Electronics Forum | Sat Sep 05 16:09:10 EDT 2015 | emanuel
Need assistance - I want to disconnect an unused LCS module from an Emerald machine. I disabled the tray changer and buffer conveyor in the machine's configuration but I still get an L212 error on the bottom of the screen and the machine hangs during
Electronics Forum | Wed Oct 03 08:34:55 EDT 2018 | smp
Dear SMTnet forum users, I'm trying to debug a XY problem that i have on a sigmaprint 500 printer. The problem is that The XY table fails to initialize and SigmaPro complains with : SigmaPro received a invalid message from slave Y_INIT_ERROR I'm
Electronics Forum | Thu Aug 12 14:55:08 EDT 2004 | johnw
Hi guys I havnt been on for a while so its nice to be back been working in europe mostly Fuji CP6 skewing rnets Marcels comment is the closest rnets are a problem as said before the main areas are 1 A good assmbley shape is a must with 30% defaul
Electronics Forum | Thu Feb 24 12:08:15 EST 2005 | siverts
Checked the condition of your nozzles? Vacuum ok? Dummy part picked from the same feeder position? Dummy part picked from the very same feeder? How often does this problem occur? How many dummys did you pick for comparison? Sometimes a feeder calibr
Electronics Forum | Fri May 30 08:24:08 EDT 2008 | cyber_wolf
The nozzles get centered at zero degrees and 180 degrees. I believe the yellow asterisk is the measurement at zero degrees, when it rotates to 180 is when you will get a red X or a green O. (In other words the yellow asterisk is normal) I think you
Electronics Forum | Fri Sep 20 08:38:30 EDT 2013 | cyber_wolf
There is a method and let me stress that you need a competent wrench man to do this.It does require a "crows foot" jig that you can probably get from a used equipment dealer. The proper way to clean the clutches is to remove them from the ring gear.
