Electronics Forum | Fri Sep 22 17:36:35 EDT 2006 | mika
A bunch of thanks guys, we will take this in consideration. BTW, we will not go for the v-grove in the panel (2x8 boards + the extra cut of areas). The board house recommended us to go for braces/hinges, since this thin pcb-panel could easily break w
Electronics Forum | Fri Aug 06 04:54:19 EDT 1999 | Scott Bradley
| I am trying to program/run a test board on a CS-400C machine for the very first time and am having problems making it run right. | | I am programming and downloading this directly out of CircuitCAM software. | | After setting the origin on the CS
Electronics Forum | Fri Jun 13 16:23:47 EDT 2014 | esoderberg
I did not see any mention on the inner layer setback. We use 0.025" and have not had problems. Point loads with either a CAB or a FKN can sometimes be problematic. I would search out someone you know that has a fancort industries VDP5. This cuts th
Electronics Forum | Mon Jun 13 18:47:56 EDT 2011 | kahrpr
Cracked parts close to the edge on pizza cutters are a common problem. There are a lot of stresses on the board as the blade cuts through the board. Raising the blade height so that the boards are not cut clean through will help. You will have to fi
Electronics Forum | Thu Aug 12 17:21:05 EDT 2021 | SMTA-64387687
Most likely you have a bad batch of PCBs. This seems like a lamination defect. Most likely, there was some contamination that prevented layers from adhering. You can cut one of the boards at the defect side and inspect the cross-section.
Electronics Forum | Mon May 21 17:37:51 EDT 2001 | davef
IPC-2222, Sectional Design Standard For Printed Board For Organic Printed Boards talks to scoring parameters in para. 5.3.1. You can obtain the standard at: http:///www.ipc.org. and Document Center [http://www.document-center.com/home.cfm/sid=71285
Electronics Forum | Fri Jun 29 15:57:24 EDT 2012 | stentech
This issue can be common on such large size boards. The newer laser we use today to cut stencils are generally accurate to +/- 5microns X and Y. Probaly way more accurate than your board which will have a +/- into thousands of an inch. Try send a boa
Electronics Forum | Wed Aug 04 20:44:05 EDT 1999 | Peter
I am trying to program/run a test board on a CS-400C machine for the very first time and am having problems making it run right. I am programming and downloading this directly out of CircuitCAM software. After setting the origin on the CS-400C and
Electronics Forum | Fri Aug 06 12:07:46 EDT 1999 | Robert Horowitz
Peter, Try calling Contact Systems for your answer. We can be reached at (203) 743-3837. Ask for the Field Service Dept. They can easily assist you. Regards, Robert Horowitz Sales Manager Contact Systems | I am trying to program/run a test boa
Electronics Forum | Wed Jan 05 07:40:06 EST 2000 | jacob lacourse
we have looked into a number of depaneling machines and can't justify the cost. what we are trying to do is to eliminate failures due to part stress when employees are breaking out the boards by hand. I heard about pneumatic scissors one day but to