Electronics Forum | Wed May 19 16:48:23 EDT 2004 | SWagner
You might have something dragging down your power supply, I have had the color monitor do this when it approachs the end of its life span, I have also had the power supply itself go bad but the voltage is usually 0. Unplug the monitors and see what
Electronics Forum | Thu May 20 16:14:55 EDT 2004 | jsk
UP AND RUNNING!!! Power supply is good but i found two loose wires in connector 12PL26 (DC to Y1). I think i may have another bad connection inside the Y1 enclosure. Monitor seems to be working OK. Thanks for your help, jsk
Electronics Forum | Fri Nov 04 11:09:46 EST 2005 | moonshine
I concur with other advice. Visit http://www.moonmanondarkside.com for much more information and free operational procedures, from the POD ftp site, for this venerable machine. MoonMan
Electronics Forum | Fri Dec 09 02:26:31 EST 2005 | Alan.
Robert, power on the machine and go straight into DOS. You can do this by pressing and holding the Shift key as the machine is booting up. Run MINT. Try re-seating the cards too before you do this. Have you checked the voltages on the card batteries.
Electronics Forum | Thu Jan 07 09:58:14 EST 2010 | kjs123p
Pull the hard drive out and use a USB to IDE adapter to copy the whole hard drive onto another computer. I do this with my reflow oven and screen printer. It works very well.
Electronics Forum | Thu Feb 04 13:21:08 EST 2010 | baildl632
I'm during this rught now and windows will not recognize the hard drive as a hard drive. It recognizes a mass storage device and that's about it. No way to copy, move or do anything o anything on the drive. Have you got any suggestions as to why?
Electronics Forum | Fri Feb 05 11:56:58 EST 2010 | kjs123p
It should show up as a mass storage device. Not to insult you intelligence, but do you have the hard drive powered up? You need to power it up if you haven't done that.
Electronics Forum | Thu Feb 18 20:19:42 EST 2010 | dekhead
Don't know if you managed to get this sorted; but at the very least need to backup your configuration (c:printerconfig.cfg) to FDD to avoid having to recalibrate entirely if it fails. If you're still having issues with Xcopying HDD feel free to conta
Electronics Forum | Sat Feb 20 20:45:53 EST 2010 | dekhead
Sounds like you have a Switched 12V issue. Breaker on rear of Machine. Fuse in Y1 enclosure. PSU3 (on floor of) Y4 enclosure.
Electronics Forum | Mon Nov 22 11:36:32 EST 2010 | mmjm_1099
I just has this issue and replaced the MIU card. I ordered it from IBE SMT. Make sure to troubleshoot before purchasing anything of course.
