Electronics Forum | Tue Jun 13 08:27:19 EDT 2006 | wrongway
Hello Mark level 4 error need to header initialize its under program data as far as mdI01 error looks like a flag field error check the F field for the item codes or fiducial codes. MDI03 error fiducial mark is not aquired need to aquire the f
Electronics Forum | Mon Sep 06 09:55:52 EDT 2004 | Joe O.B.
Hi, We're going to migrate our boards from through-hole to SMT, and I'm dealing with the PCB layout. I've found a lot of references for fiducial marks but none of them states if components can be placed beyond the marks limits or only within the are
Electronics Forum | Sat Nov 01 04:12:53 EDT 2008 | ashley
Hello mickd, The Fiducial Marks are normally etched along the vertical side of the PCB, therefore it will not be block by the XY table clamping rails. p.s. try to have a Shiny & Round Fiducial Mark as recommended by Fuji....so that you need not inp
Electronics Forum | Fri Dec 02 16:26:00 EST 2011 | davef
Here's some recommendations from various companies: * http://www.sibex.com/pcbguidelines.pdf * http://www.carltonindustriesonline.com/Docs/Fiducial.doc * http://www.tracktronics.com.au/pdf/PicknPlace_Fiducials.pdf * http://microtronix.co.za/pcb_re
Electronics Forum | Thu Jun 05 21:59:22 EDT 2008 | mika
bsumfg, The very best anybody said lately!! This should go straight into the the manual! I totally agree with you; Just an add: The fid's should never be mistaken for a test point who normally is between 1.0 - 1.27 mm so make the fids 1.5 mm. round
Electronics Forum | Thu Jul 23 13:28:55 EDT 2009 | pnguyvu
Hi PPM! Have your stencil house mark fid with laser machine - that how we use to have fid mark once it marked with laser it last very long time like stencil's life. Good luck! Steve USA STENCILS INC
Electronics Forum | Fri Nov 25 15:52:40 EST 2011 | davef
"IPC-2221 - Generic Standard On Printed Board Design" talks to fiducials. Anther take on fiducials says they shall meet the following requirements. * Make fiducials 1 - 1.5 mm diameter circle. * Cover fiducials with tin. * Keep solder mask opening at
Electronics Forum | Fri Dec 13 07:49:00 EST 2002 | pteerink
I'm no math wizard, but this is my understanding Did you ever have a spirograph as a kid? Took you about 5 minutes and endless number of lines to create one circle ( and some pretty cool patterns too ). To create a square ( or diamond ) you only n
Electronics Forum | Tue Sep 07 10:05:33 EDT 2004 | russ
Components do not have to be in the framework of the fiducials. It is recommended that the fiducials are at the outer extremeties in at least 3 corners of the assembly however. It is also a good idea to keep a minimum "keepout" area around them of
Electronics Forum | Thu Apr 01 22:03:27 EST 2004 | Ken
Are you sure it was measuring a fid? Is it possible it was measuring a block-skip mark?