Electronics Forum | Fri Sep 17 11:20:24 EDT 2010 | SMTAZ
Our facility is typically a high mix low volume site, but lately we are getting increments on our requirements therefore we are kind of struggling to cool down our ovens before to change over a different recipe ... any suggestion on how to speed it u
Electronics Forum | Fri Sep 17 11:47:37 EDT 2010 | namruht
How long of a lag do you have now on the cool down. What type of reflow oven are you using? Are you talking about change over from a Pb Free to a leaded product on the same line?
Electronics Forum | Mon Jun 13 01:38:59 EDT 2011 | kenneth0
Hello Steve, i think you are experiencing the potato chip effect, where temperature difference at the center and edges are huge; causing BGA edges to tilt down or up.Try narrow down the temperature difference between the center of BGA and corner. I
Electronics Forum | Thu Jun 14 00:21:26 EDT 2012 | tech1
If you cannot put paste down with a stencil, have exhausted all other avenues on putting paste down and the MY500 is the only machine that can put the paste where you want it... Buy it.
Electronics Forum | Mon Apr 22 04:19:09 EDT 2013 | dilogic
Parameters->Miscellaneous I/O then select Inputs and scroll down to REAR_P2P_TOWER_DOWN, select appropriate input and change State field from 1 to 0, then press OK and save.
Electronics Forum | Tue Jun 10 11:51:15 EDT 2014 | rway
Your target ppm in on the Juki machine a take it. So it's rejecting these parts due to the inversion? Any way to disable this. A right-side down resistor is not ideal, but it will certainly work electrically. Reese
Electronics Forum | Tue Jun 10 17:13:44 EDT 2014 | grauen06
I have seen this on a MyDATA machine and we had to slow our feed rate of the feeder down. That seemed to do the trick. We concluded the carrier tape was too large for the part, but our vendor didn't really seem to care.
Electronics Forum | Wed May 13 16:09:17 EDT 2015 | ttheis
After about 5 minutes of trying different code combinations I found it- hold simultaneously: F1 - Left - Down - Right FYI the setup menu pass code is: F2 - Left - Up - Down
Electronics Forum | Fri Jun 12 14:19:03 EDT 2015 | tdemon69
i have a up 3000 ultraflex. the lower half of the tactile sensor is stuck down. i have replaced the driver board, check wire down to drive board,check the fuse for power on the driver board.
Electronics Forum | Wed Apr 26 11:58:32 EDT 2017 | bobpan
Mod code 7 is a placement delay.....changing it will slow your entire program down. If you just want to slow it down for 1 placement.....you have to insert a mod code change in the sequence steps....this is easily done in central controller. Good L