Electronics Forum | Thu Jul 25 08:58:22 EDT 2019 | Matt
Hey all, i'm hoping to get some feedback from the community on baking process versus a dry box. current process we have for rework of PCBs is to perform a 16 hour bake cycle on hardware before BGA rework is performed. however this process is ineffi
Electronics Forum | Wed Jul 12 13:10:05 EDT 2000 | Dason C
John, currently, I am using the Eureka Dry Box and it is similar to McDry but cheaper and you can try and check www.aiko-group.com Rgds.
Electronics Forum | Wed Nov 08 17:01:17 EST 2000 | pallen
I know there must be a specification for this but I don't know what it is. What is the maximum psi setting for an air line that is used to dry assemblies off an aqueous cleaner? The assemblies are fixed but predominately SMT with many 0602/QFP/BGA co
Electronics Forum | Fri Sep 08 00:24:35 EDT 2000 | Jim Arnold
Sudden flux boil will cause splatter. More thorough drying or a slower intial ramp to allow drying to occur before a boil or "splatter" temperature is reached may aid your problem.
Electronics Forum | Tue Sep 05 04:19:23 EDT 2000 | P.GERARDIN
We intend to promote the new PCB cleaning process with acqueous chemistry , but we face with an important demand : Do we have to dry the pcb after ? Wich is the treshold humidity content to avoid any risk for FR4 material ? Regards Pascal
Electronics Forum | Wed Jul 12 13:10:05 EDT 2000 | Dason C
John, currently, I am using the Eureka Dry Box and it is similar to McDry but cheaper and you can try and check www.aiko-group.com Rgds.
Electronics Forum | Wed Feb 21 14:10:33 EST 2001 | kerryn
I posted a question regarding Stencil Drying in the OnBoard Forum and received some good feedback. Is there anybody in this forum that may be able to add to the information on drying stencils?
Electronics Forum | Fri Jan 22 11:46:08 EST 1999 | Michael Larsen
I was just wondering what solutions are out there for dry storage. Our basic need is to be able to store boards that have been baked and need to remain moisture free for up to a week.
Electronics Forum | Wed Feb 06 20:08:24 EST 2002 | dason_c
Francois/Sleech, thank you very much for your information, by the way where I can get the copy of the paper, what is LTVP stand for and what is the drying requirement expected ie less than 5%? I am also trying to run my evaluation to dry the parts a
Electronics Forum | Wed Jul 03 02:15:02 EDT 2002 | fogel
Need some info regarding the terms and conditions of drying bare boards before the assy. process (if need it at all). We encountered latly with delimination in some boards and I'm not sure that it is a product failure.
