Electronics Forum | Thu Jul 17 11:34:35 EDT 2003 | pjc
� Center board support: - Stationary tension wire - Adjustable width and height position (manual) - Pneumatic raise/lower feature; extends through preheat and solder wave - Minimum board clearance on bottom preheater #1 is 63.5 mm (2.5 in.) with
Electronics Forum | Mon Jun 27 15:02:55 EDT 2005 | cmiller
Thanks for the reply. I had the instructions out of the manual but after re-programming we had all kinds of wierd stuff going on. After re-setting the PC several times it worked fine. Can I get a copy of the instructions you have? It would be appreci
Electronics Forum | Thu Jan 31 11:49:21 EST 2002 | MikeF
Does anyone out there have a wave solder troubleshooting chart in electronic form they could e-mail me? I'm about to crank up a wave solder machine here, and the chart I got several jobs ago is missing in action. Also, if anyone remembers using a
Electronics Forum | Mon Jun 13 11:48:33 EDT 2005 | CMiller
We got a F04 error (internal Memory fault) on the shared drive and entered 8 in location N001 as per the maint manual and cycled the power. I then set all the locations listed in the manual to thier default settings. Now the motors do not run to thei
Electronics Forum | Mon Jan 23 14:20:32 EST 2006 | gipos
Hi Chunks, Thank you very much for your advise.It is realy helpfull.Seven years of experience are the most precious. But we have already payed the Universal Full IR.We can use it for curring of glue and paint.Do you know where we can find user or se
Electronics Forum | Mon Aug 10 21:11:00 EDT 1998 | Dave F
| Good day. We have just purchased a HOLLIS POLYCLEAN SMT Machine. We did not receive a manual and for installing the machine, we need the indications for the ventillation system: ie the number of CFM for the blower. | We would greatly appreciate i
Electronics Forum | Wed May 12 10:21:37 EDT 2004 | solderpro
having a bad morning there Gregory.... take it easy, where you from? who's company? Do you rep this firm or is this yours? I surely did not mean to disrepect your input, but I am sure there are things you need to learn that are not in the operators m
Electronics Forum | Mon Sep 08 06:50:45 EDT 2003 | cyber_wolf
Thanks. I have another question. I believe this machine was originally set up to run nitrogen. In the cooling section there are two chambers. One with a radiator air/nitrogen knives and the other section/chamber has a blower. Instead of running nitr
Electronics Forum | Fri Jun 24 13:56:05 EDT 2005 | John S
This is a little late, so I hope you've been in contact with E-vert. We've experienced the same thing on our two vectra's. It normally happens right after a bad electrical storm. The shared drive will have to be reprogrammed. E-vert can fax you a
Electronics Forum | Thu Jan 05 16:39:47 EST 2006 | pjc
Electrovert has a new nozzle design called UltraFill. It was designed specifically for Pb Free applications and generates about 40% less dross than the previous Lambda design. UltraFill can of course be used for Sn/Pb alloys. The name UltraFill is fo
.gif)
