Electronics Forum | Mon Jul 30 01:14:37 EDT 2018 | erici
Our DEK 265LT wont boot up with the DEK software. It says that the current version of the software can only run a 265GS printer, and to install the correct release of the software. Has anybody encountered the same problem? It just started happenin
Electronics Forum | Mon Dec 06 21:41:13 EST 2004 | pdeuel
I have the same problem but an MPM downstream of the Fuji. Im looking for schematics for this Fuji. Before we had another machine hooked to this Fuji and the output switch needed to be set to latch. Otherwise only a pulse was seen and it was not long
Electronics Forum | Tue Mar 20 09:25:35 EDT 2012 | dekhead
If problem is jumping from card to card; my direction would be 5vdc level. generally like it to be min of 5.15vdc on the MINT cards (top lead of 7-segment display). www.dekhead.com
Electronics Forum | Wed Apr 11 11:26:30 EDT 2012 | aj
I would recommend that you disconnect the colour monitor and replace it with a standard one.... these monitors are dodgy as hell and cause untold problems throughout the power circuitry...try it and see how you get on...
Electronics Forum | Wed Apr 11 19:53:28 EDT 2012 | dekhead
I believe the gentleman in India found a problem with one of the EuroSystem cards; AND then an issue with a corrupted PC MINT on the HDD... Seemingly resolved.
Electronics Forum | Wed Nov 06 08:23:53 EST 2019 | dekhead
If it is always showing 5.0Kg as the "target" value on the error on the first print then yes there is a problem. Are you certain that it is accomplishing the requested (12Kg ?) on the prints thereafter? Does it do Heights calibration (no tools requir
Electronics Forum | Sat Nov 09 20:16:01 EST 2019 | richardcargill
No problem. I'll get a picture of our calibration setup for you too, give you an idea of how to do it for a couple of bucks instead of getting the official calibration jigs !!
Electronics Forum | Wed May 24 15:40:08 EDT 2000 | A M
I work with a Dek 265 horizon, and i like the machine it`s very good. In this machine i work with Proflow, in the begine i have some problems but now it`s work very nice. It�s more expencive, but the stencil it�s more durable, the machine it`s more c
Electronics Forum | Tue Mar 20 05:03:47 EDT 2012 | sunyb123
Dear sir, i have face same problem of motor Communication fail Card0,Card1,I Clean Whole card properly, change the battery new one ,reprogrammed mint, but Card 2&Card3 loaded the mint programmed but not in card 0 & card 1, Please suggest what to d
Electronics Forum | Thu Aug 27 03:19:21 EDT 2020 | dekhead
Have you done Squeegee Heights calibration? (no tools required) Does it complete cal routine without error? Does pressure compensate on next print, with corresponding squeegee, following acknowledgement of pressure error? The readings calibration, ge