Electronics Forum | Wed Jul 06 14:36:05 EDT 2005 | Bob R.
The only way we can consistently get a toe fillet is to use a paste with an extremely active flux. We allow that paste on certain products, but discourage it's use because it's on the hairy edge of not meeting our lower limit in surface insulation r
Electronics Forum | Wed Apr 16 10:45:16 EDT 2003 | Takfire
Recent cross-section analysis for a customer complaint revealed voiding in the solder fillet. In some cases, the remains of outgassing were also observed. During the failure analysis, we also observed failures where the solder fillet wicked on the
Electronics Forum | Wed Jul 23 05:47:53 EDT 2003 | iman
Yo Thanks! right on the money pad, the pinhole occurs mainly in the (fillet's) top-surface central of the whole solder (fillet surface) area. Like you said, large surface area, lowest surface tension. that's a possible cause, that the potential voi
Electronics Forum | Fri Sep 09 07:55:08 EDT 2005 | davef
This pattern indicates flex cracking due to excessive bending of the board or fixture after soldering. Ceramic is strong in compression, but weak in tension. When bending causes damaged parts, look at: * Board flexes, ceramic is strong in compressio
Electronics Forum | Tue Jun 20 21:30:05 EDT 2006 | davef
The minimum vertical hole fill is defined as follows: Class 1: Not specified, with a 270-degree circumferential fillet and wetting on the secondary (solder source side) of lead and barrel, and a 75% coverage of the land area on the secondary side. Cl
Electronics Forum | Wed Mar 03 06:13:23 EST 2010 | grahamcooper22
The picture shows that the heel of the device lead is not on the pad. Either bad placement or wrong pad dimensions. I imagine most customers would reject this joint as only a small part of the lead is actually in the solder. With no heel fillet the j
Electronics Forum | Fri Mar 23 18:55:30 EST 2001 | davef
Consider posting actual measurements of your pads, component leads, and apertures.
Electronics Forum | Wed Oct 30 23:19:28 EST 2002 | caldon
Is toe fillet still required?
Electronics Forum | Thu Apr 17 13:35:49 EDT 2003 | davef
A-610 talks to acceptable voiding.