Electronics Forum | Wed Apr 17 18:27:16 EDT 2024 | acouto
Yes, it is the same type, the problem only happened after the technician removed the mark camera and the light. The manual states that you should not move the mark camera light with your hands. So I think I may have miscalibrated the equipment in som
Electronics Forum | Fri Aug 13 14:52:15 EDT 2004 | cabjerk
Hi All: I posted this thread a while back and got no response. So, I'm trying it again. We have found a machine called the GAM-20F to calibrate our Fuji CP6 feeders. Has anyone ever used one of these? The price is in the 5-6K range and is from SMT
Electronics Forum | Wed Apr 17 02:13:22 EDT 2024 | acouto
Good morning, After the visit of an external technician due to the change of cables, when resetting the camera mark again when doing the inspection fails to check the calibration points of the conveyor. Is it possible that the technician has decalibr
Electronics Forum | Fri Jun 04 09:30:43 EDT 2004 | gregf912
Grant, The Fuji chipshooters are built with the same mindset as the hydraulic presses and huge motor lathes that were the CP ancestors. The first Fuji CP was a modified motor lathe. They are solid. I can move a Fuji across the country and not have t
Electronics Forum | Thu Jul 08 12:53:23 EDT 2004 | cabjerk
Hi All: We have found a machine called the GAM-20F to calibrate our Fuji CP6 feeders. Has anyone ever used one of these? The price is in the 5-6K range and is from SMT Source. Any feedback is welcome. Thanks Carl B.
Electronics Forum | Fri Sep 14 01:48:37 EDT 2012 | dman97
Does anyone have a Fuji CP7 maintenance manual and a Fuji CP feeder calibration manual that they would like to share? We recently got a CP7 machine that is a little bit beat up and need to do some preventive maintenance to it. This machine is not as
Electronics Forum | Wed Jul 04 10:17:18 EDT 2012 | daxman
Good morning, Just a few questions to clarify: 1. You backed up your machine proper data. 2. You upgraded Fuji Flexa. 3. You re-transmitted the proper data 4. Now, components are not placing properly? Do you have a fuji 96-001 calibration board? Ha
Electronics Forum | Fri Jun 10 20:30:58 EDT 2005 | fastek
Doesn't PFA have available a calibration board kit similar to Fuji PAM? If they don't, they should.
Electronics Forum | Thu Sep 01 18:07:16 EDT 2005 | paulbendemire
We're looking into getting a feeder calibration jig. I know the Fuji is about $14k... Does anyone know about aftermarket? Is anyone using a jig currently for their CP643 feeders? Thanks
Electronics Forum | Wed Apr 17 13:48:32 EDT 2024 | jdengler
I have a AIMEX III and we have seen the top cover on the conveyor being pushed out of postion when someone does maintenance. I beleive the NXT's use the same configuration. Check to see that the cover is pushed all the way over where the PCB would
.gif)
