Electronics Forum | Wed Aug 22 14:39:02 EDT 2012 | wendynguyen234
Our S-2000 pick & place machine has head 2 not picking up any nozzle & displays error code 8342(nozzle check error). In ANC setting, head 1 pick/put ok but not head 2; when "MANUAL" box is checked, clicking PICK/PUT then both head 1 & 2's status disp
Electronics Forum | Mon Jul 28 19:03:53 EDT 2003 | Ryan Liao
Hi mantis, Thank you for your helps. I had checked the CP7 error code index application. It also gives me the same answer. It tell me " the part pickup status is bad" and I have to "Make sure that the nozzle is not bent and that the part is being pro
Electronics Forum | Fri Mar 13 15:00:18 EDT 2009 | dman97
Can somebody take a look at this screen shot and tell me what it is supposed to mean. Every time I try to transmit this program to my CP642 machine I get this error. Does any one know what this error means and how would I correct it? Thanks for yo
Electronics Forum | Tue Feb 16 08:47:38 EST 2010 | jdengler
We powered up our CP-IV today and got an error. About 7 seconds after power on page 000 comes up with nothing in any of the areas except for second status area which contains "LD INIT" in yellow. After about 16 seconds the second display area gets
Electronics Forum | Tue Mar 17 19:39:48 EDT 2009 | dman97
Never mind. I figured it out. It seems that the part numbers I assigned were too long. I shortened them to 15 characters and it worked. I find it strange that the p/n's were too long, but Flexa did not catch this as an error, and instead proceede
Electronics Forum | Wed Aug 12 18:06:33 EDT 2015 | bnorton
Here's the end of Logicomm capture on Force COMM2 where it starts the Lantern system not active messages. Couldn't get attach to work. Startup and earlier .ldx file loading omitted ulLoadTasks(): Opening the RFS pseudo device driver ... ulLoadTas
Electronics Forum | Thu Jul 09 12:47:09 EDT 2009 | janz
Hello, We are using F4G software for our Fuji machines. We've 5 machines plug into PC. Recently we tried to connect PC to local network but this only after while close C/C server without possibility to reopen C/C server. Reseting PC gives C/C lice
Electronics Forum | Tue Sep 03 05:37:06 EDT 2013 | bobpan
It sounds like your dispenser has a problem....The default mod code for 56 is 0 (this should be off). Thats why when you cleared the mod codes the machine was able to home. When you reload your saved mod codes it is probably set to 1. The machine wil
Electronics Forum | Fri Aug 30 21:54:14 EDT 2013 | nophsem
Well, the error occurs with Mod Code 56 (dispenser enable). Head # 1 has installed this accessory, but we use it very little and it wasn't this time. I probed setting 0,1,2 and 3. I downloaded Mod Codes from controller to assembler, then the error b
Electronics Forum | Thu Sep 09 13:41:43 EDT 2021 | fernsure
Tried suggested solution in manual to no avail. Reseated every connector we could get to. Has anyone run into this error, and found a solution? This error does not allow me to ignore this head and use the other two. Thanks Fern