Electronics Forum | Thu Apr 11 21:20:04 EDT 2013 | dman97
Hello. I am having a problem with a CP3 machine. This machine decides every so often to kill 24v power to its self. At first I thought it was a bad 24V power supply, but I swapped it out and it still decides to occasionally kill its self. I also re
Electronics Forum | Fri Jan 11 16:26:57 EST 2008 | rschnic
Thanks for the reply. We have software. It just won't connect when the Fuji controller (Flexa) is powered on. It appears that the controller ties up the GEM port. We were wondering if there is something that needs to be reconfigured or shutdown o
Electronics Forum | Wed Jul 07 11:40:32 EDT 2010 | daxman
Huh... Can you maybe explain a bit more? Are you getting this error on the IP3 monitor or on the programming computer? Do you use MCS, Fuji Cam or Flexa? Will the machine start up and zero-set? At which point of the power-up does the error arise? Are
Electronics Forum | Fri Nov 04 17:40:58 EST 2005 | JeffP
did not count from the time the board was > introduced, because the oven did that. What we > had to count was the seconds from the reflow > point, because it would vary from board to board > as the oven heated up. > I am not certain exactly how
Electronics Forum | Mon Jul 13 09:34:32 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would
Electronics Forum | Mon Jul 13 10:04:06 EDT 2009 | csm
Dear all, we have an Fuji CP6-4000 we get some weeks ago, but it shows an error "Hardward NG and show some actions (Inch the axis to cancel the overtravel. Then switch the power off and restart the machine). We did but display same error. I would li
Electronics Forum | Tue Mar 10 14:21:45 EDT 2009 | smellew
yes this would be normal as that is when the servo power is supplied for servo lock, do you have a new servo amp?
Electronics Forum | Thu Nov 04 06:46:19 EDT 2010 | adriana
We find the problem on Servo Pack for F theta axis .The component QM20TD-H Mediu power Switching is damaged! Many thanks!
Electronics Forum | Sat May 28 08:12:58 EDT 2011 | nirmex
Dear Gentleman, any buddy can help,how to power up FUJI NXT feeder pallet in off line for M3 and M6 feeder pallet. Thks in advance. Rgds:Nirmex
Electronics Forum | Sat May 28 16:14:04 EDT 2011 | kiss
FOV - Feeder Offline Verification. Kit is generally used with FujiTrax for verification, however it can be used to power up the entire feeder pallet while it sits on the pallet change unit of the M3 or M6.
