Electronics Forum | Fri Apr 13 12:37:35 EDT 2001 | edylc
>>> gold finger was covered by a Kapton tape and it was done offline away from the Screen printer or rather from the SMT lines itself, we are using an ENIG Pcb's , the process doesnt need a wave soldering ....however at the final end of the line ,
Electronics Forum | Mon Jul 27 17:09:20 EDT 1998 | Rin
| We are trying to reduce the number of units fail at system test due to flux on gold finger. We know so far that the flux is deposited onto the | goldfinger during touch-up or rework and to reduce the contamination we are | planning to imp
Electronics Forum | Thu Feb 01 20:21:34 EST 2001 | huat
Hi, Currently, we use kapton tape to tape out the goldfinger at our area. We still experience solder at goldfinger area, suspected is from washing of misprint boards. Can someone advice me on what is the method being use to clean the goldfi
Electronics Forum | Fri Apr 13 13:45:25 EDT 2001 | gsmguru
Just a guess-- Could you be seeing the nickel under the gold plating because you are removing some of the Gold with the Kapton Tape ? This should be easy to verify. Otherwise it sounds like things are pretty much covered.
Electronics Forum | Thu Jul 20 03:00:53 EDT 2006 | reypal
If you are using SMT machine for component placement you may check your nozzle where in some cases solder paste stuck to it and during placement will easily get into gold pad area. otherwise you have use kapton tape in order not to expose those pads.
Electronics Forum | Tue Jul 18 19:20:25 EDT 2006 | sharifudin
Actually we run lead free solder paste and the profile spec very tigh.I can't use capton tape due my product in panel form and save cost.I already verify conveyor,machine and tool free from dust and solder paste but the problem still remain.
Electronics Forum | Sat Oct 24 07:55:55 EDT 1998 | Chuck Garth
I know that this not surface mount, but many of us have to perform multipule duties. Can anyone give me some information on this I am having problems getting relibility getingthe heat seal ribbon to make consistant electrical contact. Any help would
Electronics Forum | Sun Jul 26 22:35:55 EDT 1998 | D.Lange
Masdi, Try board shunts. They are hi-temp rubber strips with grooves cut. They can be popped on and off with ease and are much faster than taping and considerably cheaper. They also work great for masking goldfingers prior to wave soldering. Contac
