Electronics Forum | Mon Aug 03 08:29:24 EDT 1998 | Dave F
SMD: Sounds interesting. What is the contact information on Steve? Dave F | Right now we are taping the goldfingers which is | effective but also expensive. Also, some tape was leaving yellow marks on the goldfingers. We're trying the so-called go
Electronics Forum | Mon Aug 03 08:23:37 EDT 1998 | smd
Stevens Products (supposedly around since 1937) 128 N. Park St. E. Orange, NJ 07019 Tel 973-672-2140 Contact: Ross Stevens, Jr. They'll take a PO but terms are net 30 Right now we are taping the goldfingers which is | effective but also expensive. A
Electronics Forum | Tue Jun 03 16:05:58 EDT 2003 | mk
Hi Randy, From a bare board manufacturers stand point, scoring is probably faster and easier but has limitations. If your boards are square or rectangle scoring will work fine. Once assembled the scored grooves can be sliced apart using what is some
Electronics Forum | Mon Oct 06 08:51:26 EDT 2003 | davef
The EIA does not provide that information. EIA standards focus on component dimensions. Alternately consider: ...cut... SM-782A - Surface Mount Design & Land Pattern Standard, Inc. Am. 1 & 2 ANSI Approved Get up-to-date land pattern recommendat
Electronics Forum | Sat May 28 19:54:20 EDT 2005 | MikeaJ
I agree with Ken, the root cause could very well be obvious. However, take a look at the following items, these checks only take a minute to accomplish. 1. If your stepper drivers are the older 5410 Pac Sci modules, check for melted power connectors
Electronics Forum | Mon May 02 18:54:28 EDT 2005 | MikeaJ
The answer you are looking for is part of your initial setup of the board and stencil. This information is to be found in the PCB setup menu/icon. The reason why the stencil loading pins are impacting the frame is because the default setting of the s
Electronics Forum | Thu Jul 04 23:17:24 EDT 2019 | 123456789
Today we will talk some other problems you may meet in the wedge bonding work. If you have any other supplement or suggestion, welcome to leave us message. Appear welding spot indentation on the frame, what's the causes? How to solve? 1.The Wedge’s
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt