Electronics Forum | Fri Aug 07 01:02:51 EDT 1998 | zeek - just wanna to get a word in here
| | I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and t
Electronics Forum | Fri Aug 08 11:44:44 EDT 2003 | Henry
I am fairly new to wave soldering and production processes, but I have been tasked with coming up with a calculation involving the shear strength of some through-hole leads. The leads are tinned copper and I suspect that tinning reduces the shear st
Electronics Forum | Wed May 16 15:40:56 EDT 2012 | davef
Here's some notes from a Bob Willis presentation Assembly of Flexible Circuits with Lead-Free Solder Alloy [Bob Willis leadfreesoldering.com] * Flexible Circuit Construction ** Base Material - 0.05mm Copper 18/18 um ESPANEX from Holders Technologies
Electronics Forum | Thu May 10 19:19:41 EDT 2007 | rgduval
Wayne, I haven't seen anything indicating that Gold Immersion is necessary for lead free... However, it is my companies preferred finish for lead free assemblies. We've taken this stance for the following reasons: 1. Better solder quality on th
Electronics Forum | Thu May 07 20:28:35 EDT 2009 | davef
From our notes, the following is a series of snips from: "Copper Dissolution in Tin" LJ Turbini, PhD, adjunct faculty member, University of Toronto, Materials Science and Engineering, SMT 2/07 As the solder becomes molten, copper from the board diff
Electronics Forum | Wed Apr 21 10:37:34 EDT 2004 | russ
Only the manufacturer of this part can tell you if subjecting the entire assembly through reflow temps is okay. It is not a good assumption that "if a part can be hand soldered it can withstand reflow" there are many connectors/headers/buzzers/etc
Electronics Forum | Tue Dec 18 17:07:50 EST 2007 | ajd400
Hello there, Please forgive the wildly-off-topic nature of this post. For a video documentary about radios in the 1920's, I'm looking for stock footage of modern PC board manufacture. (I'm a software engineer but doing this effort as a hobby). Th
Electronics Forum | Thu Jun 26 09:04:43 EDT 2003 | caldon
We had a "Spring loaded" fixture that pulled the Flex tight and used loads of Board supports. There were pins that went through the Connectors holes and held the flex firm. We only had a few components so it was no problem. Lucky for us because the f
Electronics Forum | Tue May 18 10:14:04 EDT 2004 | Rob
What affect does moisture have on sensitive components on a board as it waits for thru-hole assembly? Suppose I run a batch of boards today and the assembly dept won't be able to get to it til maybe a month from now, is it okay to just let the boards
Electronics Forum | Thu Oct 22 14:39:22 EDT 1998 | Chrys
| My company is looking for higher density for card layout. One suggestion has been locating active components packaged in SOT's and SOIC's on the B-side of the card. This in turn will require wave soldering of the above mentioned components. When I