Electronics Forum | Mon Oct 20 15:28:22 EDT 2014 | island2013
We've got a set of manuals here for the AP series. If you would like to borrow them email me.
Electronics Forum | Wed Jul 21 01:27:17 EDT 2004 | simmcircuits
Hi, I need help in aligning the stencil and the board on an MPM AP25. I have no calib jig and stencil what I did was edit w/dos editor the file ap.cal. It seems to be working OK now just a little bit of offset but what I'm concerned is the software t
Electronics Forum | Wed Dec 13 16:40:40 EST 2000 | Bill Fluegel
I am receiving a "cognex not found" error upon bootup of a MPM AP24-X stencil printer. I have checked everything I can find between the cognex computer and the one in the machine. Has anyone experienced this before? Any ideas would be greatly appr
Electronics Forum | Fri Oct 29 15:29:56 EDT 2004 | jasont
Hi Ran, Have you considered 2nd hand screen printers? We are an SMT equipment re-seller but also operate a subsidary CM factory in SuZhou, China . We use Dek 265 LT and MPM AP screen printers in our SuZhou factory and have the following in stock f
Electronics Forum | Fri Sep 21 17:35:46 EDT 2007 | valuems
the answer is very simple, it comes from 12 years of experience on the mpm's. And once you've done a calibration on the programmable print head, on a AP model you will know what I mean when I say it is not the easiest thing to do. harry
Electronics Forum | Fri Sep 20 12:32:46 EDT 2002 | cyber_wolf
Can anyone tell me where I might be able to find parts for the vision system on our AP25 printer. In particular I am looking for the cable(s) that go from the camera to the Cognex card. Thanks
Electronics Forum | Thu Jul 15 09:21:10 EDT 2004 | adlsmt
Does anyone have a diagram showing which driver cards do what in the back lower drawer of an AP-20? Or at least which one drives the camera?
Electronics Forum | Fri Oct 28 06:59:45 EDT 2005 | Rob
From what I remember there is a "snap off" setting in the AP25, where you can set the separation speed & I think it may also vibrate the board a little.
Electronics Forum | Wed May 30 21:16:05 EDT 2001 | davef
MPM AP-27 preferred over MPM AP-20 The issue is release of paste from the stencil. A vertical lift printer kinda snaps the stencil away from the board to complete the print cycle. The inertia and the rheometric properties of the paste make it rele
Electronics Forum | Wed Sep 19 04:14:55 EDT 2007 | simmcircuits
Hi, Please help on this problem with an MPM AP25 screen printer. Everytime we print the error Squeegee Pressure Not Set is prompted. Although we can still print by clicking on Next, it beats the purpose of having an automatic printing machine. Can s