Electronics Forum | Mon Sep 25 09:18:38 EDT 2006 | daxman
Thanks for the posts guys, I'd like to mention a few things... In my opinion, the tooling does not get any better than this. The board is fairly small and quite stiff. There is no board warping. The tooling plates are tight and the vacuum really h
Electronics Forum | Mon Sep 25 12:50:42 EDT 2006 | chris g
Daxman, The diagnostic results didn't look very pretty. Especially on the vision x standard deviation. Any time there is an asterisk, that is a bad thing. The failure number for all axis, excetp theta, is .0002. Could need more air flow to the x
Electronics Forum | Sat Jul 16 18:24:11 EDT 2016 | aemery
Scratches do not necessarily mean bad! Usually the forcer motor fails before a platen. The motors become weak or don't evenly distribute the supplied air, which causes them to tilt and drive into the platens. Mechanical misalignment of the VY forcer
Electronics Forum | Fri Oct 29 15:29:56 EDT 2004 | jasont
Hi Ran, Have you considered 2nd hand screen printers? We are an SMT equipment re-seller but also operate a subsidary CM factory in SuZhou, China . We use Dek 265 LT and MPM AP screen printers in our SuZhou factory and have the following in stock f
Electronics Forum | Wed Jul 21 01:27:17 EDT 2004 | simmcircuits
Hi, I need help in aligning the stencil and the board on an MPM AP25. I have no calib jig and stencil what I did was edit w/dos editor the file ap.cal. It seems to be working OK now just a little bit of offset but what I'm concerned is the software t
Electronics Forum | Tue Jan 25 13:28:51 EST 2005 | Ron Stubblefield
HELP!! I need an exploded view of the early-style (AP-20 and some 24's) camera cube. I have bought a used AP-36 and am having vision problems. I also need the cube alignment procedures if anyone has them. I already have a "C" tool. Thanks Ron ro
Electronics Forum | Fri Sep 20 12:32:46 EDT 2002 | cyber_wolf
Can anyone tell me where I might be able to find parts for the vision system on our AP25 printer. In particular I am looking for the cable(s) that go from the camera to the Cognex card. Thanks
Electronics Forum | Thu Jul 15 09:21:10 EDT 2004 | adlsmt
Does anyone have a diagram showing which driver cards do what in the back lower drawer of an AP-20? Or at least which one drives the camera?
Electronics Forum | Fri Oct 28 06:59:45 EDT 2005 | Rob
From what I remember there is a "snap off" setting in the AP25, where you can set the separation speed & I think it may also vibrate the board a little.
Electronics Forum | Fri Apr 21 16:55:16 EDT 2006 | Geo E
I am trying to find out if the AP20 MPM Printer is SMEMA ready or was it an Add-on, I can not find any documentation in the manual as to where the Smema is to be connected.Or does the diagrams show any smema hook ups. Any help would be appreciated.