Electronics Forum | Sat May 29 15:58:37 EDT 2004 | Patrick Tarell ... Automation Engineering Jabil Circuit
Hello Alan! We have used both chipshooters, we also have a Mydata with the hydra head... We switched entirely from Fuji CP7 to the UIC HSP4796 and now HSP4797. The CP7 is a nice machine but we were very unhappy with the support structure within Fu
Electronics Forum | Wed Jun 27 11:58:42 EDT 2012 | cyber_wolf
Your tool tips are being damaged because the small x-motor is not engaging when the head is picking parts. When this happens the head overshoots and you bang the tips on the mag springs. Directly after a tip gets damaged go into the service program a
Electronics Forum | Mon Oct 15 23:30:35 EDT 2001 | Ivan Rojas
Well Dave ,,, ,, first thing I should do ,, is check my CAD data , and make sure match with the program in the pick and place machine ,, right now I work with Siemens and GC-Place ,,, In my case it may be other things to look for ,,, if is everythin
Electronics Forum | Mon Apr 28 10:42:20 EDT 2003 | lgroves
Herman, I'm betting you will get a lot of response on this one. Frankly, everybody has their favorite machine. The trick is to consider the types and quantitys of boards you will run. Sometimes, it is better to set up a load for several jobs tha
Electronics Forum | Tue Jan 25 15:43:47 EST 2005 | TM
We are high mix low volume company and we use a MYDATA TP9. Very good machine that can place 0402's effectively. Issues we've had include: Maintenance - It is an older machine so, it has needed a little more than I care for. Cost of Feeders and Maga
Electronics Forum | Wed Sep 30 08:29:15 EDT 2015 | johanbergstrom
The difference between TMC Flex and TMD Flex is about the ability to feed component tape with deep pockets for larger components. The TMC have a rather low passage for embossed component tape. While TMC Flex is limited to a maximum tape depth of 7,5
Electronics Forum | Tue Oct 27 15:53:23 EDT 2009 | smtspecialist
Sr.Tech is absolutely right !!! This is where I had started, by changing all 4 brushes on the motor then I changed the connector since it was turning black (Mydata have a retrofit connector assy for that!, you can do your own also!) After trying thos
Electronics Forum | Wed Jun 04 00:28:27 EDT 2008 | chrispy1963
There are a couple of things that you can do. First thing to do is take a flashlight and shine it in the card edge connector of slot 2 and see if a passive component or any other part worked its way into that slot. This will cause multiple leads in
Electronics Forum | Fri Oct 07 16:29:52 EDT 2005 | bk
In 5+ years that I have been dealing with Mydata tech support, I never had any bad experiences. Their techs are very knowledgable of the machines. They are always courteous and patient,and if the problem cannot be fixed over the phone they always get
Electronics Forum | Tue Sep 15 02:17:37 EDT 1998 | Doug Kester
| We are a small contract assembly shop hand placing SMT. We recently received a large contract for SMD that will require placement rates of at least 6,000 CPH. I am looking at Fuji, Mydata, Quad, and Zevatech. I have little experience with automated
