Electronics Forum | Wed Oct 23 14:26:04 EDT 2019 | richgreen01
Thanks.
Electronics Forum | Wed Sep 21 12:12:24 EDT 2005 | vikkaraja
HI there, I have a problem with my TP11 HYDRA HEAD. It is not picking up parts from the magazine. I have been working with Mydata on this issue, but I have not had much success so far. So far I done the followings:ran vaccum test, tube height, and H
Electronics Forum | Thu Mar 19 18:26:30 EDT 2020 | damiendigilin
We just brought a used TP11 having some problems the computer will no longer boot as the 25VDC+ line was reporting over voltage at 31+VDC If we hit enable 25VDC+ on the power unit card it blows the 38+VDC Fuse F8.
Electronics Forum | Mon Oct 12 03:12:42 EDT 2020 | erici
TP11 is always showing the error that E-stop is not released. This happens when we start up the machine. It is basically hit and miss, sometimes will work but most of the time this error will pop up. Any suggestions on how to correct this. Is ther
Electronics Forum | Wed Dec 08 11:33:31 EST 2004 | Joe Carley
MYDATA offers the best support in the industry. I have two MYDATA machines, TP-11 Hydra and TP-9. They are very flexible, reliable, easy to program and low maintenance. Joe Carley
Electronics Forum | Tue May 28 05:41:48 EDT 2013 | Adrian
HI Sr Tech, I have a mydata TP9 for sale as spare parts machine. I think one of the board is defective. No feeders. Location: Malaysia. If interested , please send me a email: adrianchongyk@yahoo.com thanks Adrian
Electronics Forum | Thu Mar 24 10:15:56 EST 2005 | blueflag
Dear All We are using a my12 also tp11 with VIB feeders we are having major problems with ics in tubes are there any machines available to convert ics up to so16 from stick to tape & reel and are the cost effective ?????? Thanks Colin
Electronics Forum | Tue Apr 05 05:19:30 EDT 2005 | blueflag
Breakdown help machine will not 0 set upper end point limits on Z axis Theta / lower end point missed Thanks Colin
Electronics Forum | Tue Apr 05 12:45:01 EDT 2005 | cyber_wolf
Make sure your matrix tray is up high enough. The components in the matrix tray should be at least at board level. Also check your component height in the package list. If all that is OK then, check those Z locks I spoke of earlier.
Electronics Forum | Thu Apr 07 08:57:06 EDT 2005 | blueflag
have been through somethings with an engineer on the help desk and the concusion is that it is the z motor with the encoder that is causing the fuse to go so have ordered another. Not cheap though at nearly �500. Thanks very much for your help, it