Electronics Forum | Wed Apr 06 05:08:07 EDT 2005 | blueflag
New morning but still the same agro'. The story so far - Have checked the fuse on the back plane and it had blown again, changed it has been ok. Swapped the mot-z board around with piggyback mi card, no new other/moved problems. When doing base cente
Electronics Forum | Wed Mar 04 12:51:41 EST 2020 | bk
That error means your hydra z did not reach it's specified position. With the machine on you should be able to manually push the hydra down and let it come back up. Make sure it isn't being held up or hitting anything as goes down. Lots of times a pa
Electronics Forum | Fri Sep 19 10:35:56 EDT 2008 | mi
No, I don't have Panapro at all. Some Mydata files I've exported end in: *.cmp & *.gen Files saved on floppy from Panasonic MSH II end in: *.MNG, *.POS, *.SET Panasonic program filenames come out as: CF000000.POS CF000001.POS ... Sample quote of
Electronics Forum | Wed Jan 05 11:26:15 EST 2005 | cyber_wolf
Then Z MOTOR > Then select>CALIBRATE FORCE SENSOR NOTE: you must have a tool in the head when you do this.(Without the tip/spring pushed in) After this calibration the force should drop to 0 when you push in on the spring loaded tip. 2.) Replace th
Electronics Forum | Tue Jul 22 09:12:58 EDT 2008 | chiptargets
Hi, I posted a similar message yesterday, but I believe it did not make it through properly. I apologize. We have an error while trying to perform Initiate Hardware test. The error was "F-MOT1-25/205:MOVZ: Motorspeed Out of Control". The error, ho
Electronics Forum | Fri Feb 21 10:50:00 EST 2020 | tomdegas
I am getting the following error on our MY9 during hardware initialization: F-MOT-MSEDYN HYDRA Z/156 Motor Timeout After the Theta test, The HYDRA head moves slowly all the way to the bottom and then moves slowly back up and the system fails initia
Electronics Forum | Wed Mar 04 13:45:01 EST 2020 | tomdegas
I appreciate the help. The Hydra travel is fine and goes down and back up with no trouble. I swapped the Z Mot board with the Y Mot board with no change. The long ribbon cables were changed about a month ago but I will inspect them again to be sure.
Electronics Forum | Wed Jan 16 15:23:11 EST 2002 | dougt
You sound like your set to go with MyData. If you still have some time look at what Contact Systems has. Their older machines were slower compared to what is out there but they are awesome prototype machines (write a quick program, run a couple of
Electronics Forum | Mon Oct 22 08:27:49 EDT 2018 | filipblad
Hi, We're having issues with our mydata tp9 pick'n place. It doesn't go all the way down on the tool, so it can't pick it up or install it. The fault code I get when trying to install tools is F-TLMN-18: Can't reach tool bank. Any ideas? I've comp
Electronics Forum | Wed Mar 05 10:02:47 EST 2014 | dyoungquist
Per the TPSys Version 2.4 Software Manual: Force sensor level not within limits. * Force sensor dirty (inside Z tool holder) * Bad force sensor connection Try this: Remove the tool from the Z Midas head. Take a cotton tipped applicator (Q tip) and