Electronics Forum | Fri Mar 06 10:50:21 EST 2009 | fountain42
Just my opinion but it look's like your doing a great job. i would try another paste. I'm somewhat lucky that we get to use OA's. If your stuck using the no-cleans they are so tempermental. (The nitrogen is making up for the poor paste) Your de-wetti
Electronics Forum | Wed Nov 10 17:39:34 EST 1999 | Dave Vulcano
Hello, Looking for some insight. We just finished a run and experienced a lot of solder balls. We used a no clean paste, nitrogen atmosphere reflow oven, and saw the solder balls on 1206 - 0805 chip components. All of the solder balls appeared and
Electronics Forum | Fri Oct 29 13:45:03 EDT 1999 | David Vulcano
We are placing several axial components that have STEEL leads. Have noticed that the steel components do not get good flow thru(we manufacture to IPC-A-610 Class II Standards which reqires 75% flow thru) We are using Seho Wave Machines with Nitroge
Electronics Forum | Fri Jan 07 09:56:04 EST 2005 | davef
Electroformed stencil suppliers follow. The describe the stencil production process on their sites. * Aplpha Metals [ http://www.alphametals.com/products/ stencils/pdf/PG_Electroform_Stencils.pdf ] * Chepaume [ http://www.chepaume.com/electroforming
Electronics Forum | Wed May 28 09:46:48 EDT 2008 | andrzej
What I can recommend is : - clean your wave frequently, frames, etc. - looks like you have too much dross. Do you use phosphorus pills or do you have soldering alloy with phosphorus to limit as much as possible dross creation. - are you soldering
Electronics Forum | Fri Mar 20 05:07:16 EDT 2009 | rocko
Hi All, I was puzzled because of terrible blowholes in solder joints of gold plated odd-form components. I am very confused because all other components on the boards have perfect solder joints. Here are some process details: 1) Solder paste: N
Electronics Forum | Wed Aug 22 16:41:09 EDT 2018 | emeto
To all good suggestions I will add a few other thoughts: 1. Check PCB design(attached). THis mask clearance there is designed so you have some gas escape plan- verify if your PCB design follows that. 2. You can have a long soak reflow profile to re
Electronics Forum | Thu Oct 17 00:34:59 EDT 2019 | jani
Hi, We have solder reflow use with water soluble flux and Tin/lead process. There is special glass component which needs to mask during reflow soldering and wash flux+solder mask post soldering. The existing solder mask does washes off. But leaves
Electronics Forum | Thu Mar 04 08:50:53 EST 1999 | Dave F
| | I need to setup an oven to run with a nitrogen atmosphere for | boards with BGA's, but our ovens do not have the optional atmosphere monitor and controller. Is there a good way to sample and control the atmosphere without the optional built-in
Electronics Forum | Thu Jul 03 18:14:03 EDT 2003 | russ
Kris, I don't know what I HAVEN'T SEEN yet cuz I haven't seen it. (HAHAHA) It is kind of like when you are looking for something and you always say after you found it that it was the last place you looked (Why would anyone keep looking for something
