Electronics Forum | Wed May 03 06:31:30 EDT 2017 | pavel_murtishev
Evtimov, Check them: http://www.mb-mfg.com/products/surface-mount-carriers Only for instance. All can remember material I was using was black and made of pressed fibers. It was hardly treatable as well. Regards, Pavel
Electronics Forum | Fri Jun 23 15:11:11 EDT 2017 | emeto
Try add a pre-heater. If not change the process or the machine. With KISS you will hardly get any PCB to work properly.
Electronics Forum | Wed Feb 13 13:30:03 EST 2019 | emeto
I personally prefer a NC process if I have to chose. AIM flux was good NC377 I think(they keep changing names), NF 372 from and many more. You can make them all work...the KISS 104 ...
Electronics Forum | Mon May 02 09:21:14 EDT 2005 | jeglum
The beamworks new software on teh 100 is great but went to outstanding when the 60 watt leser was installed and the performance went up 60% in speed. The new software requires the temp of the solder for melting and the ammount to be despenced and the
Electronics Forum | Fri Apr 27 17:51:26 EDT 2007 | chrisgriffin
It appears a disgruntled employee has sabatoged my Sapphire solective solder. Along with cut ribbon cables, I think some jumpers were removed from the system board. D.O.M: '98. I was hoping that some nice person could take a picture of the system b
Electronics Forum | Fri Nov 14 10:40:35 EST 2014 | eniac
I use a two machines from EBSO, Germany. It's a machines with PCB carrier, so, solder pot is fixed. I'm fully satisfied with this equipment, but I use only wettable nozzles. If you would like to buy a new machine, not in used condition, EBSO will be
Electronics Forum | Fri Jun 23 12:54:53 EDT 2017 | guts1872
We are having issues with top fill and dropping pins on Molex connectors with our KISS 101. Unfortunately we do not have a pre heater and bottom side pre heat with our nozzles is not satisfactory. Most of the issues occur when using a no clean proces
Electronics Forum | Thu Apr 21 10:25:44 EDT 2005 | Fred Saffer
A thorough analysis is in order because laser point-to-point soldering lacks the flexibility of the bottom sided miniwave systems. My experience showed that heating profiles could be grossly affected by color temperature and thermal mass. This can be
Electronics Forum | Fri Nov 14 09:47:19 EST 2014 | jpal
Thanks for all the remarks. I am tending toward the move the pot method. I am concerned about parts tilting from square if moved or held at an angle. I won't need to deal with board pallets, board clamp mechanisms, etc. Plus I found the moving board
Electronics Forum | Tue May 02 02:45:14 EDT 2017 | Rob
Hi Evtimov, I've seen lower cost versions around depending on your volume - Inertec Cube being the one most recently "introduced" to us. The Sales Engineer described a custom fixture for us called a stamp that would hit every joint at once. Noth
