Electronics Forum | Thu Apr 05 09:17:40 EDT 2007 | itaig1
I have seen a method used where the pins on the connector are of the same materials as the thermocouple and the connector is connected via single strand wires of the same material to the PCB however the wires were spot welded to bare copper pads to r
Electronics Forum | Mon May 26 04:39:49 EDT 2014 | sarason
Damn near impossible. You need to see a real change in the difference between the 2 elements you are reading. So to give yourself any hope run 2 long traces one top one bottom up the length of the board. Then compare to 2 wriggly traces at one end (o
Electronics Forum | Thu Aug 02 18:33:49 EDT 2018 | sarason
I remember once working for a company that got caught during a supply shortage. Yes they were meant to get several hundred Opamps a day from there supplier. but the manufacturer fell short some 20,000 pieces. Anyway the supplier scoured the world and
Electronics Forum | Fri Apr 07 18:20:11 EDT 2000 | Gary Moravchik
Good Afternoon..... This message is for the "packaging" types in our industry. I am seeking the source of a PIND Tester (Particle Impact Noise Detector). It is used to detect whether loose bodies or contaminants may be present in a hybrid package
Electronics Forum | Wed Mar 21 18:32:45 EST 2001 | Steve
The design engineers I work with are blaming some circuit problems on what they think might be related to the no-clean flux residue. (It couldn't be the design.) Has any body else seen noise issues in high speed circuits related to no-clean flux resi
Electronics Forum | Wed Sep 05 21:53:43 EDT 2001 | SR Evers
The once famous Kester unit (now discontinued by Kester) was made in the USA and still supported by Robotic Process Sytems of Liberty Lake, WA. It is being sold and serviced under the name of the RPS 6 Sigma. It is widely acknowledged to be the mos
Electronics Forum | Fri Jan 03 16:14:37 EST 2003 | Jacques Coderre
Hi Jon, Flip Chip is chosen as an interconnect approach when one needs improved performance (high pin count, high frequency, noise reduction or improved heat dissipation.Another driver is size...Flip Chip greatly reduces the area and therefore is cho
Electronics Forum | Wed Jul 16 10:55:08 EDT 2003 | stepheno
You might want to check your input power. It is never "clean" but you might have too many spikes and transients. I've seen line monitors used and it was an eye opener how much noise there was on the input power. If you had a CPU go, you might want
Electronics Forum | Tue May 24 05:25:17 EDT 2005 | Zsolt
We had similar problem, the root cause was that the cooling fans on the VME rack were not working and the vision card hangs up if the temperature is too high. Also check the power supplies, we had also a problem that the filter condensator inside the
Electronics Forum | Wed Nov 09 08:39:59 EST 2005 | smtspecialist
Thanks Avalancher. I had no clue about the fact that Mydata could analyze part for me. Since I'm in montreal it's hard and expensive to get a Mydata guy up here but sending the parts down there would be an great inexpensive solution. I've been over t