Electronics Forum | Mon Aug 30 16:10:10 EDT 1999 | Dave F
| I have looked through the IPC web page and surfed to frustration. Can somebody give me a lead? | Brian: We don't use an etched board. We use a special stencil, described below and print on bare copper laminate. 3 Solder Wetting Test. Recogniz
Electronics Forum | Thu Aug 25 15:18:43 EDT 2005 | manish
Don, I have experienced the same thing as Russ. The fixed head systems do give the best uniformity (due to no overlap). Both Nordson and Sono-Tek offer fixed head machines that work excellent. I think the Sono-Tek system that Russ is refereeing t
Electronics Forum | Thu Apr 05 10:50:08 EDT 2001 | CAL
Per our staff here at ACI......... Higher Temperatures maybe necessary to achieve good solder process results. The alloy formed when HASL coating protects the copper is the same as that when OSP provide protection. Temperatures may be increased to im
Electronics Forum | Thu Apr 18 16:52:15 EDT 2002 | davef
General comments are: * First place I would look is the supplier of the pins that you are trying to install. Most suppliers that sell press fit components have done a good deal of work to qualify the component and will have all the specifications yo
Electronics Forum | Thu Apr 01 21:18:31 EST 1999 | Chris Kelly
Glenn, There are both very good VOC-Free fluxes as well as alcohol based fluxes out there. This should be your primary focus if you are so lucky as to have to opportunity to actually select a flux! The use of nitrogen will benefit any no-clean pro
Electronics Forum | Thu Jun 25 09:29:01 EDT 1998 | Henry Lee
| | I have a single-sided board with test vias that pass through the board. The test vias are pasted and reflowed with the SMT components on the top side. When the boards are wavesoldered, the solder coverage on the vias is spotty. Some will so
Electronics Forum | Thu Jun 25 09:29:01 EDT 1998 | Henry Lee
| | I have a single-sided board with test vias that pass through the board. The test vias are pasted and reflowed with the SMT components on the top side. When the boards are wavesoldered, the solder coverage on the vias is spotty. Some will so
Electronics Forum | Fri Jun 18 17:18:27 EDT 1999 | Jason Gregory
| | | | Now don't everyone jump on this at once, but it seems time for me to send out copies of my not even close to being dated copy of an article about HASL. Though it was published in 1992, in Printed Circuit Fabrication Magazine, and it got rave
Electronics Forum | Fri Jun 18 17:19:48 EDT 1999 | Jason Gregory
| | | | | Now don't everyone jump on this at once, but it seems time for me to send out copies of my not even close to being dated copy of an article about HASL. Though it was published in 1992, in Printed Circuit Fabrication Magazine, and it got rav
Electronics Forum | Thu Jul 20 17:01:26 EDT 2000 | Bob Willis
Here is some further information on SDSRS process, but please purchase a copy of the report from t he SMTA as all the money goes to charity. In the UK the SMART Group raised over �3000 for the homeless. SMTA have been raising a lot of money for the G
.gif)
